pfSense-Dashboard VS pfSense

I am running https://github.com/VictorRobellini/pfSense-Dashboard in grafana. Things are working, but I am having a problem getting net speeds displayed as a Stat panel. I am looking to get the current speed, but what I have is not matching pfsense traffic graph. Can anyone tell me what variables and math is needed to get the current values?

1 year or so ago I assembled this dashboard. I'm not sure if it all works anymore, I had to shift priorities, but it has what you are looking for. https://github.com/VictorRobellini/pfSense-Dashboard

It seems the dashboard was forked from this repository: https://github.com/VictorRobellini/pfSense-Dashboard

Basically, I have added the configuration from this github repo, but it's not working for me.

Victor Robellini's setup

Did you add this in the telegraf config box on pfsense? https://github.com/VictorRobellini/pfSense-Dashboard/blob/master/config/additional_config.conf

On this (amazing) Grafana dashboard, data is extracted through gwlb.inc which uses dpinger, I'm seeing the same issue:

One option is Firewalla Gold Plus, or you could buy a mini PC like it and run pfSense/OPNsense yourself.

Download and install pfsense as a virtual machine or partition: https://www.pfsense.org Configure it with the rules you want: https://youtu.be/VAGFGppSt74 Play with it, but be careful because it will block all traffic unless you check everything properly.

Another option is Firewalla, or buy a mini PC like it and run pfSense/OPNsense yourself. Two similar concepts, with the cost being either money or your DIY time. A lot of Firewalla users say that it's much easier for home use than pfSense/OPNsense, so you might find it worthwhile to spend a little more on it upfront and have to tinker less.

If you want firewall, I think you can use https://www.pfsense.org/ or https://opnsense.org/ , maybe running on an old PC or a Raspberry Pi. Not sure.

I've recently started using OPNsense. It's similar to pfSense, but seems to be considered a little more user-friendly.

For most router issues, I recommend people always put them in to dumb bridge mode and put a proper firewall like pfsense or opnsense as your gateway.

I have found that my historical average packet loss is about 0.02%. Something distinctly changed around 4/20 of this year, and now the average packet loss has gone up to 0.05% with spikes even higher, associated with periods of elevated ping times. It rarely did that before. Typically the IPv6 stack has more problems than v4 (especially an incident of packet loss on 4/28), and neither has been trouble-free since I started service in early 2020. My data comes from a pfSense installation.

I have done this using the Pfsense