operating-system VS proxmox_hassos_install

https://github.com/home-assistant/operating-system/pull/3248

BTW found exact same issue with homeassistant browsing the internet; Add support for Intel GMAC Ethernet controller (#2589) (#2593) · home-assistant/operating-system@9ca836f (github.com)

HAOS (https://github.com/home-assistant/operating-system) is not "vanilla" linux, and I have somewhat little experience of linux, although using raspberry-based systems (Domoticz, Pihole, etc) and basic usage of unix mainframes since early 90s. But the question I could not find answer for by googling is, could I use HAOS to farm chia as well, or is it too much optimized towards HA usage to reasonably serve as a chia farming computer too?

The main issue with the 3A+ is the 512MB of RAM. Combined with only having one USB port and no Ethernet, I would not advise using a pi3A+ as a sustainable foundation for HA.

Home assistant was the last thing I had running as a VM, but recently switched over to running it in a LXC container with their ContainerOS (i think that's what they call it). I would say don't do it (at least not yet), and go with their full OS in a VM (dl link to correct KVM/qcow2 version). I say don't start with HomeAssistantContainer b/c you lose Supervisor and the add-on store, and it's a bit less straighforward to get installed.

One thing to notice, I have been able to successfully boot Home Assistant OS Generic x86-64 https://github.com/home-assistant/operating-system which is using kernel 5.15+ and I don't know why I am able to boot HAOS (maybe they are using uncompressed kernel?), but not other general or special Linux distributions.

Raspberry Pi 4 64-bit

hass.io builds the whole gamut of images. There's a list at the bottom of the github page https://github.com/home-assistant/operating-system/releases/tag/8.0.rc2

I used whiskerz007/proxmox_hassos_install to do this. SSH into your proxmox node and run it from there. Once up and running, pass through the respective USB's.

i believe i used https://github.com/whiskerz007/proxmox_hassos_install but it's been quite a while since i set mine up.

me@home:~$ bash -c "$(wget -qLO - https://github.com/whiskerz007/proxmox_hassos_install/raw/master/install.sh)" bash: line 62: pvesm: command not found numfmt: invalid number: ‘failure’ [ERROR] 2@55 Unknown failure occured. me@home:~$

If you do want to install proxmox, it’s easiest to just go to the proxmox website and follow the instructions. You basically download an ISO file, put that on a USB stick, and boot up your NUC with that USB stick - that will then install proxmox on your NUC. Once you have that, it’s super easy to install Home Assistant by using this script: https://github.com/whiskerz007/proxmox_hassos_install After that you can create other VMs to your hearts content. Plenty of videos on YouTube that will help you along the way if you get stuck with it.

I’m running HA on my Proxmox server and using the Nortek Zwave/Zigbee stick. Pass through was a cinch - 1 click. No need to use Docker though. Use this script - https://github.com/whiskerz007/proxmox_hassos_install. You’ll have HA up and running in less than 5 minutes.

I'm running Home Assistant on Proxmox. The way I installed it was like this: https://github.com/whiskerz007/proxmox_hassos_install

To be honest, I don't think I ever got the official one to boot properly after installing. This is the setup I used and has been working flawlessly for months now - https://github.com/whiskerz007/proxmox_hassos_install