miryoku VS Sweep

I've seen https://github.com/manna-harbour/miryoku but it doesn't appear to be easily modified.

A 75% keyboard still require quite a lot of wrist movement, which is not ideal in your situation. It's better to learn to use layers, you could still have all the function keys and such with a 36 or 34 keys. With with such a small keyboard you don't need to move your wrist while typing. A Corne or even a Ferris Sweep can do the job with a proper keymap, like Miryoku.

If you prefer to have semicolon on Base you'd substitute custom Base, Nav, and Sym layers, swapping semicolon and slash, with https://github.com/manna-harbour/miryoku/discussions/85.

The Miryoku layout [1] has a dedicated number layer which turns the left half into a number pad. Practical (once you get used to it) and portable.

[1] https://github.com/manna-harbour/miryoku

It's understandable if some people would prefer a larger layout. I wouldn't argue people should be using smaller keyboards.

It's "I don't mind moving my hand to hit the key" vs "I don't mind holding down some Fn key to hit the key". (Or with F1-F12 on Macbooks, you need to both hold down a Fn key and move your hand).

For an example of "36 keys ... how", I think the popular miryoku layout is fascinating. https://github.com/manna-harbour/miryoku/tree/master/docs/re... -- Often, mnemonics for particular keys aren't all that complicated.

Except for those who use Miryoku, which is not optimized for software development, probably every single person here will have its own custom keymap.

The keyboard on the other desk is a wireless Corne low profile kit I built up a while back using a couple nice!nano controllers and their low power display too. For general typing I don't have much of a problem going back and forth between the two, but the Corne is only 34 keys and I use a complex layout called Miryoku to get access to most symbols and functions I have by default on my 360.

I’ve learned a lot from Seniply and Miryoku, both designed to take advantage of small keyboards. They both default to Colemak-DH, which is good.

Please also consider Ferris Sweep: https://github.com/davidphilipbarr/Sweep

there is the sweep (https://github.com/davidphilipbarr/Sweep). Also there are some sweep variants with 36 keys (https://github.com/sadekbaroudi/sweep36)

Hi guys, still did unable to connect any of the slaves. Tried kmk but no luck as well. In the meanwhile i checked again continuity, which is working for all of the pins (in the TRRS) and also found the schematics for my board if that helps: https://github.com/davidphilipbarr/Sweep/blob/main/schematic.pdf

The ferris sweep has an mx spacing variant. [https://github.com/davidphilipbarr/Sweep]

DavidPhilipbarr / Sweep

ferris sweep

Personally I use ferris sweep and I just hold left thumb button to have arrows on right hand and I use them for neovim and helix. Nevertheless you should prioritize minimalising Same Finger Usage (SFI) and comfort, they are most important for speed and to minimize mistakes. Bare minimum, I would remap j to up and k do down, but you can also remap helix function of unei to places of hjkl and think for yourself how would you like to have them placed.

I use ergonomic low-profile split keyboard Sweep[1]. My endgame (I hope so) keyboard after a long journey through the ergomechboard rabbit hole. If you're interesting in improving keyboard ergonomics with really custom solutions, r/ErgoMechBoards's Wiki [2] is a good place to start.

[1]: https://github.com/davidphilipbarr/Sweep

[2]: https://www.reddit.com/r/ErgoMechKeyboards/wiki/resources