lets-split-guide VS SoapySDR

Agree: https://github.com/nicinabox/lets-split-guide

I'm suspecting the issue may be my bad soldering, doing jumpers to connect the pads -connect jumpers step in this guide - Mine doesn't look very pretty, but I'm just not sure if that's the real issue, as I've tried to re-flow and join all four on both sides with no luck in getting the slave side to power on.

I've been building a let's split rev2 following this guide by nicinabox. The left half works as I'd expect when connected to USB but the right half does nothing when right is USB connected. If I remove the TRRS cable and plug the USB into the right half then it works mirrored. This last part makes sense it's compiled with MASTER_RIGHT define, so plugged in it thinks it's on the right.

Hi, I'm part way through building a let's split rev2 because it seems like a fun way to try a few things I've wanted to try with mechanical keyboards (building one, split, ortholinear and layers). I've been following the guide by nicinabox. The left side is working but I'm having some issues with the right side.

Are you asking where to get them? You can find more info here https://github.com/nicinabox/lets-split-guide/blob/master/getting-pcbs.md

hi, got parts for a lets split, I built it like this git page indicates https://github.com/nicinabox/lets-split-guide and flash it using the firmware found in https://caniusevia.com/

Different board but perhaps the rgb underglow guide for the Let’s Split will be helpful. Good luck!

cd ~ git clone https://github.com/pothosware/SoapySDR.git cd SoapySDR git tag git checkout soapy-sdr-0.8.0 mkdir build cd build cmake .. make

I am new to SDR and have been playing around with SoapySDR and other guides like this article.

I installed soapysdr with this: https://github.com/pothosware/SoapySDR/wiki/BuildGuide