klipper_z_calibration VS print_area_bed_mesh

Corrected link: https://github.com/protoloft/klipper_z_calibration

I recently got klicky probe setup and working, and started looking into auto z offset calibration

Fully automatic z-offset with different beds and or nozzles. https://github.com/protoloft/klipper_z_calibration takes some initial tweaking but it’s awesome

It's from auto z calibration plugin. If you have klicky, it's the bees knees. https://github.com/protoloft/klipper_z_calibration

I doubt it matters but I am running auto-z-calibrate [ https://github.com/protoloft/klipper_z_calibration ] with klicky probe + sexbolt.

Klipper Z Calibration GitHUB

so lately i'm reading a lot about Probes like the Quickdraw_Probe or Klicky-Probe. Currently using a PL-08N2 for probing. Now the will to change to a klicky probe is here looking forward to use klipper_z_calibration Plugin. So quickdraw would be a nice drop-in and everything seems easy, but vor my Voron 1.8 i can't find a decent looking dock for the probe. On the other side Klicky-Probe looks quite similar and especially the dock for the Voron 1.8 looks promising. My problem now is with the Software. I'm planning to use the Klipper specific "Dockable_Probe.md" to be most directly integrated into Klipper without the fuss dealing with those additional *.cfg's Klicky-Probe brings with it. But ony Quickdraw seems to make use of Dockable_Probe.md and Klicky as i said comes with a big load of additional cfg's i don't want to fiddle with.

Hey everyone! I'm looking for Python programmer to assist me with a klipper plugin for offset calibration for tool changer. Similar to https://github.com/protoloft/klipper_z_calibration

A macro that only probes the bed area that you are printing in aka dynamic bed mesh probing! https://github.com/Turge08/print_area_bed_mesh

Well i just wanted to use this bed mesh plugin https://github.com/Turge08/print_area_bed_mesh

print_area_bed_mesh GitHUB

Unparsed config option 'origin: https://github.com/Turge08/print_area_bed_mesh.git' detected in section [update_manager print_area_bed_mesh]. This may be an option no longer available or could be the result of a module that failed to load. In the future this will result in a startup error.

Gives this a try, it wont fix your problem but auto adjust your probed area to your print area. https://github.com/Turge08/print_area_bed_mesh

If you want to get fancy with it, check out this little gem: print_area_bed_mesh

By print_size_mesh, do you mean this macro? https://github.com/Turge08/print_area_bed_mesh

My main reason to start using it was because of a macro (not this one, but it's a better one) that only generates a mesh for the area you will be printing in. It can also reuse meshes if the new mesh is the same size or smaller than the last. Of course you can just generate one mesh and run with it for awhile, but I like having as fresh a mesh as I can and this saves time.