klipper_z_calibration VS klipper-led_effect

Corrected link: https://github.com/protoloft/klipper_z_calibration

I recently got klicky probe setup and working, and started looking into auto z offset calibration

Fully automatic z-offset with different beds and or nozzles. https://github.com/protoloft/klipper_z_calibration takes some initial tweaking but it’s awesome

It's from auto z calibration plugin. If you have klicky, it's the bees knees. https://github.com/protoloft/klipper_z_calibration

I doubt it matters but I am running auto-z-calibrate [ https://github.com/protoloft/klipper_z_calibration ] with klicky probe + sexbolt.

Klipper Z Calibration GitHUB

so lately i'm reading a lot about Probes like the Quickdraw_Probe or Klicky-Probe. Currently using a PL-08N2 for probing. Now the will to change to a klicky probe is here looking forward to use klipper_z_calibration Plugin. So quickdraw would be a nice drop-in and everything seems easy, but vor my Voron 1.8 i can't find a decent looking dock for the probe. On the other side Klicky-Probe looks quite similar and especially the dock for the Voron 1.8 looks promising. My problem now is with the Software. I'm planning to use the Klipper specific "Dockable_Probe.md" to be most directly integrated into Klipper without the fuss dealing with those additional *.cfg's Klicky-Probe brings with it. But ony Quickdraw seems to make use of Dockable_Probe.md and Klicky as i said comes with a big load of additional cfg's i don't want to fiddle with.

Hey everyone! I'm looking for Python programmer to assist me with a klipper plugin for offset calibration for tool changer. Similar to https://github.com/protoloft/klipper_z_calibration

Hello group. I have a question about neopixels. On my Marlin setup I defined Neopixel and Neopixel2. All LEDs ran off of the same pin. I was looking at this example. https://github.com/julianschill/klipper-led_effect/blob/master/docs/LED_Effect.md On this it shows 3 separate pins. So now I am confused. Can someone please explain to me how this works. I am just a beginner at this.

Neopixel Led’s: https://github.com/julianschill/klipper-led_effect

However, it is possible using klipper_led-effect

I'd suggest playing around with that until you feel like you are comfortable with it, and then if you want to start looking into animations and such you can check out klipper-led_effect. Just be warned (IMO) it's kind of confusing to configure.

These macros

LED Effects GitHUB

Yeah as a matter of fact klipper-led_effect literally just added this option yesterday.

Ok cool. What I'm trying to do is to add a Neopixel ring to the underside of my build plate (don't worry, I've already sorted out thermal insulation so they don't burn) and have it change colour automatically based off certain parameters. I want it white and breathing slowly when it turns on, changing from blue to red while it's heating and between 30⁰ and 60⁰, then breathing red while it prints. Finally it would turn green upon the print completing, and then go in reverse order from red to blue and back to white as the bed cools and lands below 30⁰. I've been researching this shit all day and have started to build a led_progress.cfg as instructed by this page, however, according to this page I can have all kinds of control over the lights.