Marlin VS Marlin

To compile for the GD32's in Platform IO set the ldscript for the compile as such: https://github.com/Voxelab-64/Marlin/blob/091a28308faa37df94dacb65f981d5390daa7bff/buildroot/share/PlatformIO/ldscripts/creality.ld

You’ll need the Voxelab Aquila source code. Download the zip from https://github.com/Voxelab-64/Marlin and click the green code button, then download Zip.

I modified and cleaned a bit the code from https://github.com/flashforge-64/Marlin

Also in my trials I was trying to get thier repo ( flashforge-64/Marlin: Marlin (github.com) working in VSCode with PIO, To get it to compile I just copied the platformio.ini from marlin bugfix and replaced the one in the repo and that let me build it in vscode.

Okay long story short, I just got my printer yesterday and already installed the BL touch to it (a clone). I followed all the steps necessary to flash and update the firmware both on the main board and display. At first it wasnt working because I have the new chip on the main board which I found the reddit post for. So now that I was able to flash the custom firmware (using Grippy98's build) I noticed that the auto home would only work with X and Y while the Z would not home at all. I know it does this because the BL touch should be used as the Z endstop but it literally just stalls on it and does nothing. So I can hit auto home and it will go to the middle of the bed then stops. When I hit auto level, it does nothing and I can't cancel it on the screen. The BL touch should be enabled and move the Z axis down but it doesn't do anything. I was able to get the Z axis to home using the limit switch by editing Configuration.h but again, when I hit auto level it does nothing and stays still. I think some people were having similar issues but I swear there's not a single simple answer on this subreddit. I've been searching for hours. If anybody could shed some light, I would be very grateful. I've been pulling my hair out for hours trying to make this work

I recently got a Voxelab Aquila as my second printer but I'm having issues connecting to pronterface, so I can set my Z probe offset for the BLTouch. I installed a CFW that I found on here by the user named Grippy98. The CFW has a Z offset tool that i can use in the meantime, but i would still like to access pronterface in the future. I tried everything from changing the USB cables, baudrate, COM ports, and using three different PCs. My Ender 3 never gave me this issue. My device manager shows "USB Serial" with a yellow exclamation point icon, when the printer is connected. It doesn't seem to be recognizing it. Does anyone know what could be causing this? Thanks in advance.

Hi All, I've compiled Marlin 2.0 Bugfix for the Aquilla. This version works for both GD32 and STM32 variants. Repository if you want to build your own: https://github.com/Grippy98/Marlin