everything-sovol-sv06 VS DGUS-reloaded-config

My friend, your machine can't handle those speeds. Here are some of my prints: https://github.com/bassamanator/everything-sovol-sv06/blob/39477b317da7dac40efbb3a844a3fb36dead922d/images/prints/README.md. You can try to reduce the `max print speed`, start off by limiting it to 60-70mm/s (match the other profile's speed). I hope you've made other adjustments to the `printer settings` as well so that it works with marlin.

You can get a raspberry pi zero 2 w for $15 bucks from any of the authorized retailers. I just bought one the other day for a mobile retropi I’m putting together. They have them in stock now. I run it on a pi 4 but I’ve read about a bunch of people here on Reddit who run klipper on a pi zero and have no issues. klipper install guide. This guide is pretty good for walking you through the setup process.

https://github.com/bassamanator/everything-sovol-sv06 SV06 here, might browse a bit for the 01 Pro.

You'll find the essentials here.

There is this site someone else in the community made https://sv06.blakadder.com/ and there is also the klipper github repo https://github.com/bassamanator/Sovol-SV06-firmware. The same user of the klipper repo also maintains a parts repo too https://github.com/bassamanator/everything-sovol-sv06 but the site also seems to have the same info

You can find specs here: https://github.com/bassamanator/everything-sovol-sv06

If you are not a tinkerer, I would suggest you get rid of this printer, because it will act as a thorn in your sides. On the other hand, if this is truly your hobby, you can expect to get prints such as these. I'll put up my sub $300 SV06 with severe x-twist against a more than $1000 MK4 any day!

great resource for info on sv06

Designing this part? You can find the link to the official CAD models for this printer at the bottom of this repo, might help the design process.

Long story short, I missed that Desuuuu was merged into marlin starting with Marlin 2.0.9.2 which is the current stable release. The example configs I found for Desuuu are for 2.0.9.1 (https://github.com/Desuuuu/DGUS-reloaded-config/tree/2.0.x/examples/Creality) and the marlin (stock) examples are newer (https://github.com/MarlinFirmware/Configurations/tree/release-2.0.9.2/config/examples/Creality/CR-20%20Pro). If you check https://github.com/MarlinFirmware/Configurations/blob/release-2.0.9.2/config/examples/Creality/CR-20%20Pro/Configuration.h, that does mention the Desuuu screen files:

I managed to find this