compactyl VS dactyl-manuform-tight

As they said, not by dometyl, rather Derek's separate plate Compactyl.

This keyboard is an attempt to make a best-of-both-worlds combination between the modular (and support-saving) design of dereknheiley's compactyl manuform (with adjustable wrist rest mounts) and the trackball-enabled design of the noahprince22's tracktyl manuform, forking the firmware from Schievel1's dactyl_manuform_r_track.

A couple of minor changes i might make for 5.1, but STLs available at https://github.com/dereknheiley/compactyl if you'd like to build it asap.

The spacing depends a lot of the configuration, for example some iterations of Derek's compactyl made for SA caps have had very close edge to edge key spacing. Also centre to centre key spacing on key wells is easy to get tighter than Choc spacing, so even if you've configured with a little more gap for whatever your keycaps are compared to mbk, a press between them is going to be less off-centre than it would be for chocs (which also perform worse with off centre presses than mx).

The v4 STLs should be in the repo, that's what's pictured above. I rarely go back and change old STLs unless there's a glaring issue. https://github.com/dereknheiley/compactyl/tree/master/things/compactyl-v4.0-5x6-hotswap

I've modified dereks compactyl to remove the last row and get a regular 3x5, but I'm assuming you'll want to have the DM thumb cluster with 5 buttons rather than the compactyl one with 3, right?

Dereks compactyl repo also provides an adjustable way to position crystalhands palm rest.

additionally there are several on github, mine is like https://github.com/dereknheiley/dactyl-manuform-tight but there are at least three others i can’t find from my phone

With these ideas in mind I went looking for images of keyboards that I thought would fit and came across the Tightyl by u/Okke (Github Repo). I loved the low-profile design. With a tent, the dactyl curve, and the 3-key thumb cluster, it was a perfect fit.

My end goal is to basically make a modified version of the Tightyl. Specifically, my goal is to make a Tightyl with the left hand side being 5x5 and the right hand side being 5x6, with built-in Kailh hot-swap socket posts.

This Tightyl build by u/moltarpdx is based on u/Okke's work (git, STL).