Voron-Stealthburner VS klipper-led_effect

Can you please post photos and description of your printing environment, type of filament for those parts, which hotend you used, etc. in this issue: https://github.com/VoronDesign/Voron-Stealthburner/issues/68

HI. It's a standard Stealthburner. https://github.com/VoronDesign/Voron-Stealthburner

This will behave completely identically to the official one that u/imoftendisgruntled linked.

First album image: Slicing stealthburner_printhead_rapido_rear_cw2.stl, looking at the layer with the largest horizontal bridges.

You should be able to control them from your web UI. Or I would install the sb config file (https://github.com/VoronDesign/Voron-Stealthburner/blob/main/Firmware/stealthburner_leds.cfg) and then use one of the macros to test it from the console.

Any of the supported hotends from the Stealthburner repository: https://github.com/VoronDesign/Voron-Stealthburner/tree/main/STLs/Stealthburner/Printheads

These are the files for the V6 hotend. The StealthBurner works with a bunch of different hotends, each needs its own mounting bracket, which is printed.

Yeah take a look at these

Try printing the clockwork 2 guidler parts (A and B) from here. The tolerances are tight and the two pieces need to fit together snugly. If they won’t fit or are loose then you have to tune more.

Hello group. I have a question about neopixels. On my Marlin setup I defined Neopixel and Neopixel2. All LEDs ran off of the same pin. I was looking at this example. https://github.com/julianschill/klipper-led_effect/blob/master/docs/LED_Effect.md On this it shows 3 separate pins. So now I am confused. Can someone please explain to me how this works. I am just a beginner at this.

Neopixel Led’s: https://github.com/julianschill/klipper-led_effect

However, it is possible using klipper_led-effect

I'd suggest playing around with that until you feel like you are comfortable with it, and then if you want to start looking into animations and such you can check out klipper-led_effect. Just be warned (IMO) it's kind of confusing to configure.

These macros

LED Effects GitHUB

Yeah as a matter of fact klipper-led_effect literally just added this option yesterday.

Ok cool. What I'm trying to do is to add a Neopixel ring to the underside of my build plate (don't worry, I've already sorted out thermal insulation so they don't burn) and have it change colour automatically based off certain parameters. I want it white and breathing slowly when it turns on, changing from blue to red while it's heating and between 30⁰ and 60⁰, then breathing red while it prints. Finally it would turn green upon the print completing, and then go in reverse order from red to blue and back to white as the bed cools and lands below 30⁰. I've been researching this shit all day and have started to build a led_progress.cfg as instructed by this page, however, according to this page I can have all kinds of control over the lights.