Special_Configurations VS MRiscoCProUI

Have a look at https://github.com/mriscoc/Ender3V2S1/wiki/How-to-update-the-display I had an Ender 3 V2 with a TJC display that needs a special compile to display the numbers. You can find the specially compiled firmware bin's here: https://github.com/mriscoc/Special_Configurations/releases/tag/tjc

PID tuning - Using Pronterface and the M303 command, I get "PID Autotune failed! Bad Heater id". Searching on this one I found the man himself mention " using an MPC version of the firmware, so there is no PID for the extruder". The firmware I used is an MPC version - so I need to run the MPC autotune instead. I cant run it as I can't home the head.

-I am using the Touchscreen with the included cables. I have the singular pin with the touchscreen's 5 pin connection on the left if the drivers are at the top of the board. - The broad rate set to 115200 -I am using a CR touch with the 5 pin connector in the 5 pin CR touch thingy -I am using this firmware, " Ender3V2-SKRME3V3-BLTUBL-T13-LA-MPC-20230809.bin" on this page https://github.com/mriscoc/Special_Configurations/releases I have not edited it because I have no clue how to do that

As well as a T13 version (https://github.com/mriscoc/Special_Configurations/releases/download/T13/Ender3V2-422-BLTUBL-T13-MPC-20230812.bin)

See here: https://github.com/mriscoc/Special_Configurations

I basically went through the Marlin config file for my printer line by line to change it how I like. You might also want to check out Professional firmware, he as many precompiled configs, and the source code. I think his has a 10 minute hotend timeout in it.

You're welcome :-) Mriscoc has a special configuration version of the firmware with linear advance enabled, https://github.com/mriscoc/Special_Configurations/releases/tag/LinearAdvance

I used mriscoc T13 be sure to follow the directions.

This is where it has moved to

I don't know much about compiling firmware but it might be better to base the edits on Mriscoc instead of Alex's as it has much better support for the H32 chip so should be a lot easier to compile.

I'm see that there are newer firmware available. This one (https://github.com/classicrocker883/MRiscoCProUI/releases), for example.

I just thought of another thing you could try. Give Mriscoc ProUI FW as it may have the option to configure this or is already properly set up for this version of the probe.

If for some reason your FW does not support those Gcodes then update it to the latest version, or try Alex's or Mriscoc ProUI firmwares.