Renoir-Mobile-Tuning VS ryzen_smu

Found a solution. I used this to set maximum temperature as 90 degrees. Now I get the same performance but temp stays at 90.

Renoir Mobile Tuning - https://github.com/sbski/Renoir-Mobile-Tuning/releases

it's for 2020.. use this for TDP manipulation https://github.com/sbski/Renoir-Mobile-Tuning/releases. is on the pinned posts

Renoir Mobile Tuning, It is an app that can change TDP and temperature values for AMD renoir processors. It is available on Github: https://github.com/sbski/Renoir-Mobile-Tuning

@ 4000 series you could use Renoir-Mobile-Tuning to lift power, temp and current limits.

I only do it when I'm trying to be quiet, but I use Renoir Mobile Tuning

You can try https://github.com/sbski/Renoir-Mobile-Tuning

Not sure if that's entirely correct...

for Ryzen cpus there's ryzen_smu which appears to be able to do this. not sure about Intel.

For sensor and whatnot, check out corefreq and ryzen_smu.

Attempting to install Ryzen smu on fedora and I am using the "Stand-alone" installation as I understand that fedora/debian/arch are different.

Only out-of-tree modules being run are drivers for rtw8852be wireless card and ryzen_smu. The retbleed flag is not set and I'm running ext4, not f2fs.

For AMD, if you have query access to the SMU coprocessor, you could use corefreq and ryzen_smu; they're for sensor readouts, and they do slightly different things. ​(And Zentimings and HWiNFO for windows.)

Check out corefreq and ryzen_smu; they're for sensor readouts, and they do slightly different things.

That said, the ryzen_smu tool for linux exposes "CLDO_VDDM", which reads out to 0.9504 volts, regardless of load.

Check out this guide. Also check out Ryzen SMU for better sensor readings on linux.

I forgot to mention, Ryzen SMU can be used to for sensor reading.

CPU/RAM overclocking is best done via the firmware, so at worst you're missing out on sensors and other readouts. That said, if you have a ryzen, there are a number of tools available.