OctoPrint-Creality2xTemperatureReportingFix VS Octolapse

so just ssh out to octopi and run this? pip install "https://github.com/SimplyPrint/OctoPrint-Creality2xTemperatureReportingFix/archive/master.zip"

Here's an older tutorial on having Octolapse call on gPhoto2 to get the DLSR images - https://github.com/FormerLurker/Octolapse/wiki/V0.4---Configuring-a-DSLR

"Installing plugin from https://github.com/FormerLurker/Octolapse/releases/tag/v0.3.4... Error! Could not install plugin from https://github.com/FormerLurker/Octolapse/releases/tag/v0.3.4, was neither a plugin archive nor a single file plugin"

Try installing from the plugin manager by clicking 'get more' and using this url: https://github.com/FormerLurker/Octolapse/archive/refs/heads/devel.zip

If you get an error when installing it like I did, this page was helpful. You can download the zip and install it from the plugin manager. https://github.com/FormerLurker/Octolapse/issues/787

Have you gone through the Octolapse guide? https://plugins.octoprint.org/plugins/octolapse/. There’s a lot of info in there with suggestions. It mentions the wiki. That’s a great resource too: https://github.com/FormerLurker/Octolapse/wiki

This is the link to the instructions for enabling Custom Image Preferences.

Trying to install octolapse, so far its the only plug in giving me issue, all the others work fine.. I just get this - Installing plugin "Octolapse" from https://github.com/FormerLurker/Octolapse/archive/master.zip...

Some stringing is unavoidable (especially for bowden setups), but excessive stringing is usually settings related. If you have not done so, go through this guide and make sure 'automatic slicer settings' are used and correctly configured. If you are using Prusa Slicer, make sure you enable 'verbose gcode'. The smart layer trigger is usually your best bet, or 'snap to print' if you are more interested in quality vs a perfect timelapse. Lastly, check out this official guide on print quality. Good luck!