MxLEDBitPCB VS qmk_fw

I've tried the MXLEDBitPCB personally for a dactyl and it worked great. (I used the "Container" variant). My dactyl case holes were a tiny bit too big, but once i got the hotswap sockets in, it held the keys well enough to stop the wiggle. My only complaint is that the 5x5 PCB layout made it a pain to break them apart, and it left little fiberglass nubs i had to sand down. The labeling was a bit easier to understand than the Amoebas, but it also not as fancy. The big advantage these have, is they support through-hole diodes, as opposed to tiny smd diodes.

dometyl can generate keywells with hotswap socket slots, you can hot-glue/crazy-glue them in place or just yolo them in place. I prefer to use 1u pcb's, since soldering wire to them is much easier. The MxLEDBitPCB atlanta support hotswap sockets and you can have many manufactured very cheaply by jlcpcb.com.

These PCBs: https://github.com/swanmatch/MxLEDBitPCB/tree/master/container

MxLEDBitPCBs have a Choc variant, too: https://kbd.news/MXLEDBitPCB-1060.html

Also worth noting that Amoeba Royale has very small LED solder pads compared to mxledbit's "container" ( https://github.com/swanmatch/MxLEDBitPCB/tree/master/container ) board.

. The trouble? I got the Altana board made which only supports sk6812 mini LEDs (for an underglow I suppose) and do NOT support the sk6812 mini *-e* LEDs which tend to be the first result that come up if you just search sk6812 mini. See this wonderful github thread of another fellow keyboard enthusiast making the same mistake. In fairness the support rubric is pretty clear so I was just being stupid/hasty/whatever.

I much preferred the idea of SK6812MINI-E LEDs, but couldn't source a PCB that worked with chocs and also the MINI-Es. I decided to try handwiring one, then found the MxLEDBitPCB: the choc version supports MINI-Es, and it looked as if it might make handwiring a little more straightforward for a relative newbie.

It's per-switch using PCBs from this repo: https://github.com/swanmatch/MxLEDBitPCB

Hey all! I'm trying to put together a handwired dactyl build with hotswap and RGBs in each switch using the MxLEDBitPCB Amoeba.

MxLEDBitPCB altana from jlcpcb $6 with shipping - you may want to choose the container version if you want backlighting but the wiring if more involved so I did not go this route

Specific firmware (and some readme's on implementation) is here: https://github.com/christrotter/qmk_fw/tree/arcboard-mk13/keyboards/handwired/arcboard_mk15/keymaps/christrotter

More detail here.

- clear eeprom however you can, test again; don't ignore this, figure out how to do it - docs have info as well. this is how i'm doing it: https://github.com/christrotter/qmk_fw/blob/arcboard-mk9-3x5/users/christrotter/build.sh

Ok, here's my branch: https://github.com/christrotter/qmk_fw/tree/arcboard-mk9-3x5

code is a janky copy of tractyl_manuform: https://github.com/christrotter/qmk_fw/tree/arcboard-mk9-3x5/keyboards/handwired/tractyl_manuform_ct (embrace the jank, right?)