Marlin-2-0-x-Anycubic-i3-MEGA-S VS Marlin-2.0.X-MKS-Robin-Nano

You can try the marlin version from Knutwurst. https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S

I don't have the Pro, just the S - but just finished up installing a 3d touch about 5 minutes ago using this firmware and tutorial/wiki: https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S The guide also has the wiring / pins /etc.

I would recommend using https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/releases firmware as its more up to date and has good documentation

The Knutwurst is here: GitHub Knutwurst

https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S You can download the already compiled version for the drivers you installed.

I followed the guide linked in this github page: https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S

If you print too fast, skipping is likely to occur. This is a separate issue from the firmware. It's also possible that the new firmware is causing an issue. What firmware are you using? There is only one firmware for this printer: https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S There is no other viable option!

Hi. I flashed firmware from this repo https://github.com/le3tspeak/Marlin-2.0.X-MKS-Robin-Nano to my Sapphire Pro z TMC2209 but my Z axces engine don't work. Who have working firmware to the Sapphire Pro z TMC2209?

No need to be paranoid about updating firmware on a Sapphire Pro ... I am using this repo https://github.com/le3tspeak/Marlin-2.0.X-MKS-Robin-Nano/releases ... it is a Marlin 2.0.6 version ...

I am not quite sure but I think you have to uncomment line 947 in your Config.h

There was already existing a Firmware by l3tspeak on github which was not including configurations for the Hemera nor the Dual-Z Revision, but the BLTouch is already included (As I remember). But I didn't tried that BL-Touch yet. I had no need for that yet.