Laser_tape_reverse_engineering
Alternative firmware for a cheap X-40 laser tape measure (by iliasam)
stlink
Open source STM32 MCU programming toolset (by stlink-org)
Laser_tape_reverse_engineering | stlink | |
---|---|---|
1 | 11 | |
118 | 4,219 | |
- | 1.1% | |
4.5 | 8.2 | |
7 months ago | 8 days ago | |
C | C | |
MIT License | BSD 3-clause "New" or "Revised" License |
The number of mentions indicates the total number of mentions that we've tracked plus the number of user suggested alternatives.
Stars - the number of stars that a project has on GitHub. Growth - month over month growth in stars.
Activity is a relative number indicating how actively a project is being developed. Recent commits have higher weight than older ones.
For example, an activity of 9.0 indicates that a project is amongst the top 10% of the most actively developed projects that we are tracking.
Stars - the number of stars that a project has on GitHub. Growth - month over month growth in stars.
Activity is a relative number indicating how actively a project is being developed. Recent commits have higher weight than older ones.
For example, an activity of 9.0 indicates that a project is amongst the top 10% of the most actively developed projects that we are tracking.
Laser_tape_reverse_engineering
Posts with mentions or reviews of Laser_tape_reverse_engineering.
We have used some of these posts to build our list of alternatives
and similar projects.
-
Golf rangefinder repurpose
this might help https://github.com/iliasam/Laser_tape_reverse_engineering
stlink
Posts with mentions or reviews of stlink.
We have used some of these posts to build our list of alternatives
and similar projects. The last one was on 2024-04-05.
- Embassy 在 Blue Pill 上的点灯案例
- How can I manually flash a program to an STM32 chip without the IDE
- GD32F103C8T6 can replace an STM32F103C8T6?
-
How to upload code to STM32 using stm32flasher (linux & UART)
I see stlink clones on ebay for $7. The stlink software runs on linux : https://github.com/stlink-org/stlink. Or use pyocd.
-
Programmer/Debugger circuit that I can add on my dev board?
This one?
-
STM32 Nucleo CLI development
I did do a little bit of digging since this post. I think my distro has this set of tools:https://github.com/stlink-org/stlink
-
Pro dashboard and firmware
I flashed mine using the flasher included into a Stm32f4 discovery board I had laying around. Used this toolset https://github.com/stlink-org/stlink to flash the firmware. Not sure if you can use UART to flash, if that's so, you might be able to use a raspberry pi or Arduino as an interface which is far way more accessible than the stlink flasher.
-
What professional software exist to program embedded devices?
Usually the better tools (eg. Segger's J-link, st-link with st-util, OpenOCD) can emulate a GDB-server to which you can connect from a gdb or from the debug session at your IDE.
-
Need help to get start with Blue pill [Clone]
In order to get into stm32 development I bought a cheap stm32 blue pill clone (STM32F103C8T6) and a ST-LINK v2. I tried to get the info by using the st-info --probe command in the open source version of STlnk tools. I pluged in the stlinkv2 connecting the headers correctly to the dev board and the boot1 and boot0 was in 0 position, no additional connection was given.
-
Ada in STM32F429 Discovery Board
Have a look here: https://github.com/stlink-org/stlink/issues/651 Maybe you have the same problem.