Klicky-Probe VS whopping_Voron_mods

I used this github as a guide to get my servo to work on my BTT SKR Mini E3 V3 https://github.com/jlas1/Klicky-Probe/tree/main/Printers/Voron/Switchwire then you have to mess with the pulse width value until it works right, lots of trial and error

So you want to use this one? https://github.com/jlas1/Klicky-Probe/tree/main/Printers/Voron/Switchwire

GitHub, there's the install for all the different variants (klicky, unklicky and the ng variants), with macros, boms and instructions https://github.com/jlas1/Klicky-Probe

I just went through the same build and I just included the klicky files as specified here, edited the variables file and that was it

The official Klicky setup for the Switchwire uses one as well

Rainbow Barf SB LED Logo with Linneo Black LED diffuser

The bracket goes in the back like shown here

The mounts are the Whoppingpochard design.

I built a 300, and I can see the bi-metal extrusion warping without gantry backers that seems to be the biggest concern with going larger. (https://github.com/tanaes/whopping_Voron_mods/tree/main/extrusion_backers)

Insufficient heat soaking. As the chamber warms up the frame members deflect from thermal expansion, causing the toolhead to rise. In my experience you need a good hour or so with the doors closed for temperatures to stabilize enough, on a stock build. Putting backers on the Y rail extrusions can mitigate this as well: https://github.com/tanaes/whopping_Voron_mods/tree/main/extrusion_backers