Klicky-Probe VS Quickdraw_Probe

I used this github as a guide to get my servo to work on my BTT SKR Mini E3 V3 https://github.com/jlas1/Klicky-Probe/tree/main/Printers/Voron/Switchwire then you have to mess with the pulse width value until it works right, lots of trial and error

So you want to use this one? https://github.com/jlas1/Klicky-Probe/tree/main/Printers/Voron/Switchwire

GitHub, there's the install for all the different variants (klicky, unklicky and the ng variants), with macros, boms and instructions https://github.com/jlas1/Klicky-Probe

I just went through the same build and I just included the klicky files as specified here, edited the variables file and that was it

The official Klicky setup for the Switchwire uses one as well

if your going to go with a 5015 fan setup and probing. i recommend giving Stiffy a look, this integrates two 5015 and [annex quickdraw clicky probe (>10euros to make)].

so lately i'm reading a lot about Probes like the Quickdraw_Probe or Klicky-Probe. Currently using a PL-08N2 for probing. Now the will to change to a klicky probe is here looking forward to use klipper_z_calibration Plugin. So quickdraw would be a nice drop-in and everything seems easy, but vor my Voron 1.8 i can't find a decent looking dock for the probe. On the other side Klicky-Probe looks quite similar and especially the dock for the Voron 1.8 looks promising. My problem now is with the Software. I'm planning to use the Klipper specific "Dockable_Probe.md" to be most directly integrated into Klipper without the fuss dealing with those additional *.cfg's Klicky-Probe brings with it. But ony Quickdraw seems to make use of Dockable_Probe.md and Klicky as i said comes with a big load of additional cfg's i don't want to fiddle with.

more information here, https://github.com/Annex-Engineering/Quickdraw_Probe/tree/main/Klipper_Macros

With the quickdraw probe https://github.com/Annex-Engineering/Quickdraw_Probe