Ender_SW VS VoronUsers

For an Ender, have you considered converting it to a Switchwire? https://github.com/boubounokefalos/Ender_SW

https://github.com/boubounokefalos/Ender_SW for the modded Ender 3 build with or without an enclosure.

If you have an ender 3 pro/v2 Boubounokefalos conversion

Pretty sure you can use this project for the S2, no linear rails on the front of the uprights. https://github.com/boubounokefalos/Ender_SW

I followed this guide https://github.com/boubounokefalos/Ender_SW. Well documented and easy to build. The umbilical is work in progress.

Designers GitHub: https://github.com/boubounokefalos/Ender_SW/tree/Rev.2

270º Clamping Hinges

Hotend is a Triangle Labs CHC Pro. Extruder setup is a mixture of a couple 😅 -mod of Mantis Toolhead to mount on MGN9C

Stealth skirts by Maverick

Those are a duct remix of this design, it is not yet posted since I need to install my wires to make sure no changes are needed. It will probably be uploaded in the next week.

I'm running a Chainflex umbilical cable + a beacon probe USB cable along the prebowden. I'm thinking about running the Bowden guide to help, I'm not pinching anything when I home the printer, but I'm looking to keep everything up and out of the way. https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/Galvanic/Bowden_Tube_Guide

Here is a good cfg to automate the fans

basically copied and pasted from here: VoronUsers/bedfans.cfg at master · VoronDesign/VoronUsers · GitHub with printer specific info bellow

Why don't you submit this to the vetted mods repository? https://github.com/voronDesign/voronusers

I swapped to these magnetic bottom panels and they are awesome!

I noticed that you mentioned being annoyed by the cable management (or lack of it) in the kit, which I think is probably not uncommon with many kits with some exceptions (LDO looks nice). That bothered me also, so I'm also working on something to help with cable management, which may also work with the Trident (a remix of these cable ducts).