Ender_SW VS Klicky-Probe

For an Ender, have you considered converting it to a Switchwire? https://github.com/boubounokefalos/Ender_SW

https://github.com/boubounokefalos/Ender_SW for the modded Ender 3 build with or without an enclosure.

If you have an ender 3 pro/v2 Boubounokefalos conversion

Pretty sure you can use this project for the S2, no linear rails on the front of the uprights. https://github.com/boubounokefalos/Ender_SW

I followed this guide https://github.com/boubounokefalos/Ender_SW. Well documented and easy to build. The umbilical is work in progress.

Designers GitHub: https://github.com/boubounokefalos/Ender_SW/tree/Rev.2

I used this github as a guide to get my servo to work on my BTT SKR Mini E3 V3 https://github.com/jlas1/Klicky-Probe/tree/main/Printers/Voron/Switchwire then you have to mess with the pulse width value until it works right, lots of trial and error

So you want to use this one? https://github.com/jlas1/Klicky-Probe/tree/main/Printers/Voron/Switchwire

GitHub, there's the install for all the different variants (klicky, unklicky and the ng variants), with macros, boms and instructions https://github.com/jlas1/Klicky-Probe

I just went through the same build and I just included the klicky files as specified here, edited the variables file and that was it

The official Klicky setup for the Switchwire uses one as well