ArduinoJoystickLibrary VS MPU9250

I'm at a good point with the code and the hardware, but I ran into this issue where the library says that you can define up to 2 hat switches, and I need to use both and here's the problem.

I have a project where I want to turn a hall sensor Apem joystick into a PTZ-controller in OBS to control cameras in a live stream. I am using this library: https://github.com/MHeironimus/ArduinoJoystickLibrary

I would use a joystick-library like https://github.com/MHeironimus/ArduinoJoystickLibrary

I used the joystick library for arduino https://github.com/MHeironimus/ArduinoJoystickLibrary. Very easy to code, especially following this video. You can also map other types, such as x, y, z axis, rudder, accelerator, plus buttons. I'm planning to add a TO/GA button and AP/ATHR disengage buttons.

Yep, my bad. I got confused with the numbers. Also, did some googling and from what I can see here even though you can map more than 32 buttons the default Windows joystick tester won't display them.

This example might help you get you started. You can't directly "assign" a pin to an axis with this library. However, you can approach it a couple different ways.

I'm using this library.

I was just looking at using the https://github.com/hideakitai/MPU9250 library as well as the joystick library to create a headtracker. The magnetometer gives the reference point to correct for gyro drift.

Also are you using the following MPU9250 library? If not then what are you using? hideakitai/MPU9250: Arduino library for MPU9250 Nine-Axis (Gyro + Accelerometer + Compass) MEMS MotionTracking™ Device (github.com)

So, I'm not a C/C++ programmer at all, but I still decided to give it a go. I'm using the https://github.com/hideakitai/MPU9250 library to extract data from the sensor which has worked fine.