ATEM_tally_light_with_ESP8266 VS Adalight-FastLED

So the tally lights I am building are based on an ESP8266 Board (Wemos D1 mini). The software is used, as is, from here: https://github.com/AronHetLam/ATEM_tally_light_with_ESP8266

Software and Hardware used: I am using Adalight Fastled (https://github.com/dmadison/Adalight-FastLED) with a WS2812B strip.

Run Adalight with Prismatik.

The sketch I used for the DIY Ambilight can be found here: https://github.com/dmadison/Adalight-FastLED/blob/master/Arduino/LEDstream_FastLED/LEDstream_FastLED.ino

Use this code instead. Define the LED type, data, and clock pins at the top.

Of course, here it is: https://github.com/dmadison/Adalight-FastLED

I have uploaded a sketch Adalight-FastLED to an Arduino Mega. The following description is the requirement for my c# app that is using a slightly modified Ardity to send byte[] instead of strings to the Arduino.

another warning: the off the shelf kits come with a relatively low baked-in baudrate (115200, but confirm with your seller), this might limit your LED framerate, read this, so don't set your software to 360-noscope-fps capture right away... so either you are fine with what you'll get and you leave it at that or you want a higher rate, in which case you'll need to flash it with any other arduino ambilight sketch (such as this) with values that work for your board (any arduino ambilight tutorial on the subject will do)

I used this: https://github.com/dmadison/Adalight-FastLED If you need any further help, dm me. I'm electrician, so I didn't need to learn how the electronics work.