grblv1.1-laseraxe reviews and mentions
Posts with mentions or reviews of grblv1.1-laseraxe.
We have used some of these posts to build our list of alternatives
and similar projects.
-
Probe not working
I have a CNC with grbl laseraxe v1.1, my board doesn't have the best instruction manual so not everything is labeled but after some time with a multimeter I figured out where port A5 is, I located it because thats the pin indicated in the cpu map https://github.com/1wise/grblv1.1-laseraxe/blob/master/grbl/cpu_map.h. I checked the other pins indicated and they match so this one should as well. 4.6V is on A5 when the probe isn't touching and is grounded(0v) when they do touch. I'm using UGS(V2.0.12) and making it probe but when they touch it simply keeps moving, I also tried inverting it ($6 = 1). What should I do?
-
Axis issue - tried everything I could, don't know what to do
I looked at what what the arduino was outputting on the logic analyzer, it was on d2-d8, I wrote down what all the commands did and then I tested where the connections went, they didn't match. I tried changing the pin configuration on cpu_map.h but that didnt work, I found grbl laseraxe(https://github.com/1wise/grblv1.1-laseraxe) which had the same pins and it WORKED!!! :))))))))))))))))
Stats
Basic grblv1.1-laseraxe repo stats
2
11
10.0
over 6 years ago
1wise/grblv1.1-laseraxe is an open source project licensed under GNU General Public License v3.0 or later which is an OSI approved license.
The primary programming language of grblv1.1-laseraxe is C.
Sponsored
SaaSHub - Software Alternatives and Reviews
SaaSHub helps you find the best software and product alternatives
www.saashub.com