-
megaTinyCore
Arduino core for the tinyAVR 0/1/2-series - Ones's digit 2,4,5,7 (pincount, 8,14,20,24), tens digit 0, 1, or 2 (featureset), preceded by flash in kb. Library maintainers: porting help available!
-
InfluxDB
Power Real-Time Data Analytics at Scale. Get real-time insights from all types of time series data with InfluxDB. Ingest, query, and analyze billions of data points in real-time with unbounded cardinality.
I am programming the Tiny via UPDI through a Arduino Nano using the Arduino IDE with the MegaTinyCore. It does verify the code after upload. I can use a 1306 display (I2C), and manipulate all the GPIO's with no issue. I can use the same GPIO that I have hooked the 18B20 up to for anything else, just not 1-Wire. I have tried other GPIO with the same response. I am using the example for the Dallas Temperature and update the pin assignment. The exact same code works fine on a 328P with the same sensor, so I dont doubt it is a library issue but I'm not experienced enough to figure out exactly where the issue could be.
I am programming the Tiny via UPDI through a Arduino Nano using the Arduino IDE with the MegaTinyCore. It does verify the code after upload. I can use a 1306 display (I2C), and manipulate all the GPIO's with no issue. I can use the same GPIO that I have hooked the 18B20 up to for anything else, just not 1-Wire. I have tried other GPIO with the same response. I am using the example for the Dallas Temperature and update the pin assignment. The exact same code works fine on a 328P with the same sensor, so I dont doubt it is a library issue but I'm not experienced enough to figure out exactly where the issue could be.