split-vpn VS vpntv

With Router side VPN it shows up in the DPI.

yes i as well think this is sad that such things are not passible "easy" through the frontend. you can look at https://github.com/peacey/split-vpn to see if you can get such working but its then not an out of the box solution again.

Honestly just use this, it works wonderfully with wireguard vpn providers and you can assign a specific subnet, VLAN, or interface to the VPN tunnel.

This is what I use. I have a wifi and connected to a separate vlan that routes through my openvpn connection provided by expressvpn. Any device connected to that wifi goes through the VPN connection. https://github.com/peacey/split-vpn

I use wireguard on the UDM Pro unofficially to route as a client, and here's some extensive performance testing I did. Typically, the UDMP/SE is perfectly able to saturate a 1 Gbps connection up and down through wireguard.

There is VPNTV as well, as an pocket VPN solution for TV, XBOX, etc.

Check vpntv for hardware page. There is list of compatible WiFi to USB dongles and hats with links.

You can do the same with Raspberry Pi Zero and VPNTV. Basically, you need to connect RPI to Ethernet port and it will up WiFi AP to your devices.

You can run OpenVPN instance on free Amazon AWS tier with openvpn-aws and use vpntv as a client. Or just install OpenVPN-connect as a client on your device.

I recently purchased an LG TV panel that came with a new jailbreak-fixed firmware, which meant that I didn't have the option to use an OpenVPN client. This made it difficult for my kids to watch legal TV series and cartoons that were geographically locked outside of 🇺🇦. So, I decided to create my own solution - vpntv.