rtl88x2bu VS 8812au-20210629

To me this sounds either like bad drivers or bad hardware. There is a reasonably easy way to rule out drivers; test it in linux. Unfortunately this card is not supported by the kernel, however there are drivers available on github. You can test this in a "Live Linux" environment, where you do not have to install it to disk, all you should need is a USB stick and some patience.

Given that a T3500 didn't come with WiFi back in 2011, I'm guessing this is a USB network adapter. Maybe try this github repo. https://github.com/cilynx/rtl88x2bu

git clone https://github.com/cilynx/rtl88x2bu.git

https://github.com/cilynx/rtl88x2bu Seems like you have to compile these drivers to get the adapter working. I also have a TP-Link wifi adaptor and TP-Link doesn't support the newer Linux kernels and they haven't added it to the Linux kernel by default so it's a bit of a pain to get this working. But if you can figure it out and get it working congrats lol

Is the relevant information... The issue is the rtl88x2bu driver that is built-in to the kernel... It isn't very good. You could consider an alternative driver like https://github.com/cilynx/rtl88x2bu using these instructions.

If you are running Kali bare metal or if you have allowed USB pass through then it is most likely a driver issue. Take a look at this repo.

You'd first need to tether your laptop to your phone, then install the kernel headers (sudo pacman -S linux-headers), choose the one that matches your kernel version. Then install this driver. It's in the AUR. Make sure you get the one that says "DKMS" on it.

I've been trying for a few hours now to install drivers for a rtl8812au based usb wifi adapter (Edimax-7822ULC/UTC) on a nanopi r6c running kernel version 5.10.110. Zero luck with both the manufacturer driver for ubuntu and with an open source one-size-fits-all (https://github.com/morrownr/8812au-20210629). When running the manual install for morrownr's open source driver, I'm getting this error:

Is this a non-standart kali vm? If yes and you are learning, never sudo apt update/upgrade unless specifically told by your instructor. The adapter works for me with the drivers and intructions on github link

I have a dongle with that chipset, used it couple of times, worked fine. The driver I used is from here https://github.com/morrownr/8812au-20210629

Unofficially, the chipset itself seems to be the Realtek RTL8812AU chipset, which does have community support up to the current 6.1 kernel, but latest tested on Fedora is 5.11. (it will probably work, but honestly it's still a gamble). The work seems to mostly spur from the AUR repository, which links here.

As seen in the picture, every other ping seems to be about one second long and every other somewhat it should be. Pinging directly my Router via WLAN. There are different drivers available for the RTL8812AU, currently using this one: github.com/morrownr/8812au-20210629. The same issue persists using other drivers available. Power saving settings for the adapter are turned off, no effect.

The driver is available on github.

git clone https://github.com/morrownr/8812au-20210629.git

I had to reinstall a newer version of my driver ---> https://github.com/morrownr/8812au-20210629/issues/67

First you will need to find out which version you have. Version one or two (this one) will need this driver. For version three (this one) you will need this driver.