qmk_toolbox VS sea-picro

Flashing custom firmware - the current version QMK tool off the website won't work. You'll most likely get a "USB device connected (NO DRIVER): WB Device in DFU Mode " and not be able to flash anything. You will need the beta version that supports WB32 flashing utility. I grabbed mine from the GMMK guide QMK tool from GMMK

You first have to download QMK toolbox https://github.com/qmk/qmk_toolbox/releases/download/0.2.2/qmk_toolbox.exe. Once downloaded, download this bin file https://github.com/GHv4/Sense75-CAPSLOCK-UNDERGLOW/blob/main/sense75-CAPSLOCK%20UNDERGLOW.bin. Open the QMK toolbox exe file, then hit the open button. Locate the .bin file. Hold Right FN+BACKSPACE until it pops up in QMK Toolbox. Hit flash and wait for it to finish flashing. Via and Vial compatible. YOU'RE WELCOME FRIENDS!!

Flash it with qmk toolbox: https://github.com/qmk/qmk_toolbox/releases

I got things working by using the https://github.com/qmk/qmk_toolbox project, and the firmware file you linked. As you said, my pad now works with Vial, and has 12 layers. Though the layer selector still only traverses between layers 0 through 3.

- QMK MSYS: you'll need it for many things, for compiling your firmware file and for flashing, especially if flashing with QMK Toolbox isn't permitted in firmware settings (in this case QMK Toolbox just won't recognize your keyboard);

I am currently using the QMK online configurator tool to do the compilation and download the resulting .bin file, and then the QMK Toolbox to flash it onto the keyboard.

Check out this site: http://kpchn.com/s/PoHJ. I found it from the AliExpress page and it leads to all the VIA/VIAL configs for the KPRepublic boards. Go into CSTC75 and you'll see a .hex file, that's the firmware. You should be able to use the QMK toolbox: https://github.com/qmk/qmk_toolbox to flash the firmware.

Tool needed to flash your keyboard (QMK Toolbox) can be downloaded here: https://github.com/qmk/qmk_toolbox/releases/tag/0.2.2

When I first plugged them in, my Mac (running 13.1 Ventura) recognized them as a USB storage device. I was trying to use the QMK toolbox to flash the firmware onto them, not realizing that I needed to drag and drop a .uf2 file instead of trying to flash a .hex file.

The are some MCUs that provide a separate 5V GPIO pin for LEDs, the Sea Picro for example.

I ordered a Chocofi kit that included two Sea Picro microcontrollers and am running into issues getting the firmware I want installed and working.

Agreed regarding going RP2040, but I’m liking the Sea-Picro over the KB2040 for replacing a Pro Micro. The Sea-Picro has:

I'm going to start my own Ferris Sweep build and I'm looking for verification or corrections on making the sea-picro swap-able, so that it's not directly soldered onto the board. I'd like to be able to switch it to wireless someday or easily replace the sea-picro if it goes bad.

I'm new to this. I don't know anything about electronics, I just wanted a split minimalistic split keyboard for ergonomics. The pre-built Ferris Sweep I ordered came with the Sea Picro microcontroller. The QMK Config seems to only compile into .hex but apparently, I need a .uf2 file. Dumbed-down step-by-step instructions would be highly appreciated. Thanks