wireguard-tools VS wireguard-docs

Also I'd recommend this script to configure and maintain wireguard configuration. Cheers

u/psyhomb has created this script: https://github.com/psyhomb/wireguard-tools, which appears to be doing exactly what I need (bulk creation of peers). What I don't understand, though, is the following:

I suggest trying this script, it will make your life significantly easier. ;)

Also you can try this powerful but easy to use script.

I would recommend using this script to ease manual configuration process and to avoid these or similar kind of issues. Cheers

I can recommend this script, it isn't UI but still it's very easy to use CLI that you can use not only to generate client configs but also to configure servers as well (hub-and-spoke architecture).

You can achieve this by using this script. ;)

I can’t find info about this in the quickstart guide. Are these the docs you’re talking about?

I think the official documentation is clear enough on the settings, and I don’t think the project can necessarily be blamed for others misinterpreting it. True, the AllowedIPs label can lead to some confusion for those who don’t read the docs. I think of it as those destination IPs that can be reached through the peer, and those source IPs that are accepted from the peer. See also this site: https://docs.sweeting.me/s/wireguard

You prolly should give a /32 on your interface ips. Here is this as well https://github.com/pirate/wireguard-docs. I don't understand exactly what you are trying to do, but if you are trying to pass traffic anywhere you need to enable packet forwarding at the Kernal level.

By the way, look at https://github.com/pirate/wireguard-docs

Thanks for the reply. I'm not sure which missing lines you're referring to though? According to this documentation, PostUp is used to run a command after the interface is initialised (same for PostDown, which apparently runs a command after the interface is deleted), but I'm not sure what commands exactly I'd need to run PostUp or PostDown for?

Find more example commands for inspecting the interface at https://github.com/pirate/wireguard-docs#inspect.