VoronUsers VS TheFilterSingle

You wouldn’t be the first one to switch over ;) https://github.com/nateb16/VoronUsers/tree/master/printer_mods/nateb16/THE_FILTER

If you are planning on using it with a Voron, you may want to look into The Filter. It seems like its probably a better design. If you are going to use it with another enclosed printer it probably doesn't matter.

I just installed “The Filter” and took out the nevermore and the 3 bed fans I had running for chamber temps. Running the filter with the dual fan and the two side pods with individual fans seems to heat chamber even faster. link to The Filter

I think the advantage of the nevermore (or the filter which is what I used) is that you get a decent improvement in chamber temp. But, you can also just do this with bed fans and no internal filter. If my bed filter eventually fails, I'm probably just going to punch a hole in the wall and vent things straight out to the garage. I'll then just have bed fans.

The filter by nateb16 - heats the enclosure way faster and filters the ABS smells. I say it's better than the Nevermore

I went straight to a Stealthburner+cw2, Canbus(SB2040)/umbilical and Voron Tap out of the box but those are optional. I also gotten ACM for the deck and bottom covers. Otherwise minor items were wiring duct and extra WAGO connectors to make 5v and 24v power rails for future expansion. IMO changing the z sensor and ACM is the mandatory ones followed by the duct. Also consider "The Filter" rather than the Nevermore The Filter

Scratch that, I kinda just think i was able to make a single fan mod myself. Thanks to your provided .f3d. I only made it based on one side.,But I figure you just print two of the same, and then use two different pogo mounts? I made my own repo and uploaded my f3d there. See what you think. https://github.com/devsfan1830/TheFilterSingle