nanoCH32V305 VS nanoCH32V203

If you are willing to try r/RISCV ones, then nanoCH32V203 (with two Full-Speed interfaces) and nanoCH32V305 (with one Full-Speed and one High-Speed interface) might be enough.

There are dual USB r/RISCV boards with GPIO pins exposed, like nanoCH32V203 and nanoCH32V305.

There are RISC-V MCUs that have two USB interfaces, but those are not supported by QMK yet. I tried some of those boards in kite project.

Kite has standard shortcuts option too, but it runs on dedicated MCU board, not host PC.

RISC-V boards cost $3-$6 depending if you want high speed USB or full speed one.

u/Bounty1Berry is exploring RISC-V nanoCH32V305 board, but it's a new board that is not supported by (Q|T|Z)MK yet, so not really go-to option at this stage.

Their earlier boards like nanoCH32V203 and nanoCH32V305 were more user friendly, one could flash those via USB without WCH-Link.

Muse Lab has MCU boards like nanoCH32V203 and nanoCH32V305.

It runs on nanoCH32V305 dual USB r/RISCV MCU board.

If you are willing to try r/RISCV ones, then nanoCH32V203 (with two Full-Speed interfaces) and nanoCH32V305 (with one Full-Speed and one High-Speed interface) might be enough.

There are dual USB r/RISCV boards with GPIO pins exposed, like nanoCH32V203 and nanoCH32V305.

Another alternative is to use dual USB MCU board like nanoCH32V203 as USB CDC relay.

RISC-V boards cost $3-$6 depending if you want high speed USB or full speed one.

Their earlier boards like nanoCH32V203 and nanoCH32V305 were more user friendly, one could flash those via USB without WCH-Link.

Muse Lab has MCU boards like nanoCH32V203 and nanoCH32V305.

The same form factor as nanoCH32V203, but with more RAM and storage, also one of USB interfaces is high speed and SDIO is native this time. Comparable to CH32V307 boards, but lacks ethernet port.

Speaking of hardware there is very nice $3 RISC-V board that would fit well USB to USB converter use case. No keyboard firmware is ported to it yet.