ch32v003
CH32V003 is an ultra-cheap RISC-V MCU with 2KB SRAM, 16KB flash, and up to 18 GPIOs that sells for under $0.10 (by openwch)
nanoCH32V203 | ch32v003 | |
---|---|---|
8 | 4 | |
50 | 300 | |
- | - | |
10.0 | 4.9 | |
over 1 year ago | about 2 months ago | |
C | ||
- | Apache License 2.0 |
The number of mentions indicates the total number of mentions that we've tracked plus the number of user suggested alternatives.
Stars - the number of stars that a project has on GitHub. Growth - month over month growth in stars.
Activity is a relative number indicating how actively a project is being developed. Recent commits have higher weight than older ones.
For example, an activity of 9.0 indicates that a project is amongst the top 10% of the most actively developed projects that we are tracking.
Stars - the number of stars that a project has on GitHub. Growth - month over month growth in stars.
Activity is a relative number indicating how actively a project is being developed. Recent commits have higher weight than older ones.
For example, an activity of 9.0 indicates that a project is amongst the top 10% of the most actively developed projects that we are tracking.
nanoCH32V203
Posts with mentions or reviews of nanoCH32V203.
We have used some of these posts to build our list of alternatives
and similar projects. The last one was on 2023-04-14.
-
Recommend MCU with dual USB - one host and one device IF?
If you are willing to try r/RISCV ones, then nanoCH32V203 (with two Full-Speed interfaces) and nanoCH32V305 (with one Full-Speed and one High-Speed interface) might be enough.
-
RP2040 based MCU for dactyl in the works
There are dual USB r/RISCV boards with GPIO pins exposed, like nanoCH32V203 and nanoCH32V305.
-
Hi, I have a Linux based device and I need to use one of it USBs to broadcast data. I want to send the UART data on it. The thing is it's USB is host(master) and it's useless for my project so I want to change it mode to behave like a slave device and thus I am able to communicate with a PC. Armbian
Another alternative is to use dual USB MCU board like nanoCH32V203 as USB CDC relay.
-
USB Dongle to convert Colemak keyboard to QWERTY keystrokes?
RISC-V boards cost $3-$6 depending if you want high speed USB or full speed one.
-
nanoCH32V003 board
Their earlier boards like nanoCH32V203 and nanoCH32V305 were more user friendly, one could flash those via USB without WCH-Link.
-
Hardware/software to run RISC-V ASM?
Muse Lab has MCU boards like nanoCH32V203 and nanoCH32V305.
-
CH32V305 Development Board from MuseLab
The same form factor as nanoCH32V203, but with more RAM and storage, also one of USB interfaces is high speed and SDIO is native this time. Comparable to CH32V307 boards, but lacks ethernet port.
-
ð¥MK: Use programmable keyboard firmware with any keyboard.
Speaking of hardware there is very nice $3 RISC-V board that would fit well USB to USB converter use case. No keyboard firmware is ported to it yet.
ch32v003
Posts with mentions or reviews of ch32v003.
We have used some of these posts to build our list of alternatives
and similar projects. The last one was on 2023-08-04.
-
A Single-Cycle 64-Bit RISC-V Register File
There are some MCUs that use RV32E also - the CH32V003 [0] comes to mind.
[0] - https://github.com/openwch/ch32v003
- CH32V003 Printf Serial Diagnostic Output?
- nanoCH32V003 board
-
2x 2538 SMD LED for the key switch. How do I make this workout?
Higher interest in the mechanical issue. Kailh box aren't made for 5050-equivalent-sized LEDs so the best I can come up with is placing them on a daughter board with some distance and just accepting losing some light. Probably will use a low-cost microcontroller and R2R leader (current sink) to make them addressable. Alternatively, make use of the 11 bit PWM and LC filter while the ADC forms the feedback loop. Currently unsure if I go with WCH CH32V003 (https://github.com/openwch/ch32v003) or Padauk MCUs. A couple of kHZ PWM should be fine but if I make a PCB I might as well just go all in with PWM-free.
What are some alternatives?
When comparing nanoCH32V203 and ch32v003 you can also consider the following projects:
nanoCH32V003
minimax - Minimax: a Compressed-First, Microcoded RISC-V CPU
ch32v-keyboard
nanoCH32V305
xmk - Use programmable keyboard firmware with any keyboard.
ch32v307 - Including the SDKãHDKãDatasheet of RISC-V MCU CH32V307 and other relevant development materials
keymap-editor - A web based graphical editor of ZMK keymaps.
yaemk-split-kb - 5x8 Split keyboard with thumb-clusters, rotary encoders and oleds.
evsieve - A utility for mapping events from Linux event devices.
qmk_port_ch582
nanoCH32V203 vs nanoCH32V003
ch32v003 vs minimax
nanoCH32V203 vs ch32v-keyboard
ch32v003 vs nanoCH32V305
nanoCH32V203 vs nanoCH32V305
ch32v003 vs nanoCH32V003
nanoCH32V203 vs xmk
nanoCH32V203 vs ch32v307
nanoCH32V203 vs keymap-editor
nanoCH32V203 vs yaemk-split-kb
nanoCH32V203 vs evsieve
nanoCH32V203 vs qmk_port_ch582