TTS VS Arduino_GFX

Ive tried the same code which i use for the arduino but changed the gpio pin to 0(D3) on the node mcu. The code does get uploaded but didnt receive any audio output. What do I need to change in order for it to work. Here is the link to the library which does mention it supports esp8266. Here is the example code.

The link to the github page.

There is a really crappy-sounding text to speech library for arduino. I think it's a pretty good feat that the programmer was able to get this to run on an arduino at all, but it sounds even worse than the 80's text-to-speech chips.

There are also pure software TTS solutions available such as this library that claim to run on a plain Arduino Uno without much external hardware other than perhaps some form of amplifier. I have not used this library myself but it looks interesting.

Some of the contents of the sdkconfig.defaults come from the documentation by Espressif some by peeking at the Arduino_GFX library, used in the example code.

According to the supplied source code, the default installed software is using Arduino_GFX and is using 20 GPIOs for a parallel interface (DE, Vsync, Hsync, PCLK and 5:6:5 rgb).

I'm using the above combo with the Arduino GFX library . https://github.com/moononournation/Arduino_GFX Got it to work ok - no problems until I reboot the esp. The ESP won't boot up until I remove either the power or gnd from the lcd. I know that some esp pins can't be high/low durin boot up or boot will fail - but is there some way of over coming this issue? I don't want to keep disconnecting power upon reboot or skecth upload.

Here's the library i am currently using https://github.com/moononournation/Arduino_GFX