hidusbf VS hid-remapper

When I overclock my controller my frames drop significantly. I hold a stable 240 frames normally, however when I use https://github.com/LordOfMice/hidusbf overclock with a PS5 Dualsense controller it stutters my frames to 30 every now and then. I'm running a 2080 with a i9-9900k if that matters. Any solutions?

I used to use this to overclock my controller https://github.com/LordOfMice/hidusbf

the name of the program is called hidusbf you can find it here:https://github.com/LordOfMice/hidusbf what does the program do ?

I was trying to play Elden Ring but every time i moved my mouse it caused huge fps drop. So I searched for a solution. I came across this reddit post. From which i decided to change the mouse polling rate. I couldn't find a program specifically made for my mouse so i find a third party one from github. I did everything it said in the correct order but my mouse doesn't work anymore. When i connect it to the pc, its lights turn on for about 10 seconds then go back off. Other mice work fine. it is just this one i tried on.

And here is the GitHub Page with the Tool, and Explanations how to use it. https://github.com/LordOfMice/hidusbf

Here is the test https://github.com/chrizonix/XInputTest and here the link for the overclock https://github.com/LordOfMice/hidusbf

You could use HID Remapper basically a USB dongle that sits between your device and computer. It's hardware based so no installation on company device, program it at home, plug n play. Supports macros too. Very cheap and easy to build.

Try to build this: https://github.com/jfedor2/hid-remapper

If you do not need WiFi or BLE, take a look at https://github.com/jfedor2/hid-remapper. Works on Adafruit Feather RP2040 with USB Type A Host board. Or use a raspberry pi pico board and wire in a USB Type A host connector. The USB host works by bit-bang assisted in hardware using the PIO.

Here's another solution that is OS independent. I configured mine so that if I hold right click, moving the ball scrolls. Right click works normally when clicked. https://github.com/jfedor2/hid-remapper

The best way I have found is to build an HID remapper and remap the buttons with its web interface. I know most would prefer a software solution but this is very intuitive and gives you so much control over the device.

I know this open source device exists, which among other things can do polling rate overclocking to ensure 1 kHz polling rate.

There's always HID Remapper!

Bill and myself did some e-mail exchanges this week starting about April 25. He is quick. He managed to get the hid-remapper (https://github.com/jfedor2/hid-remapper) from Jacek Fedoryński (jfedor2) working on this new RP2040 and we got our first taste of tremor filtering with the new device.

That would be Pico-PIO-USB library or some people combine two Pico boards (or one board with two RP2040 MCUs).

Check out hid-remapper. It allows remapping of all Slimblade buttons with a lot of flexibility.