espusb VS NoiseTorch

It's unfortunate that https://github.com/cnlohr/espusb stopped with ESP8266

Rule of thumb: never say something isn't possible on the ESP-8266 without confirming that cnlohr hasn't already done it.

There is a software only library for USB1.1. I have not tested it but it should be usable. https://github.com/cnlohr/espusb

Apparently someone did something similar for the 8266! https://github.com/cnlohr/espusb

ESPUSB https://github.com/cnlohr/espusb

Better tooling/libraries? I would imagine that shoehorning audio support into espusb [0] is going to be quite a chore.

[0] https://github.com/cnlohr/espusb

This: esp8285 usb

Noisetorch. https://github.com/noisetorch/NoiseTorch

Interesting! How does it compare with NoiseTorch/RNNoise?

Interesting! I'm currently using NoiseTorch-ng. Although NoiseTorch works well, I don't like that you need to reload NoiseTorch every time you change a setting.

I till now haven't figured out how to setup noise reduction in PipeWire. In Pulse, it was very easy. At the present, I'm using https://github.com/noisetorch/NoiseTorch.

(I do like PipeWire)

You could always try NoiseTorch. https://github.com/noisetorch/NoiseTorch

Maybe it will be possible to integrate this or something like this to SteamOS, given it's using PipeWire: https://github.com/noisetorch/NoiseTorch

If Apex allows you to select a mic, you can make a virtual (filtered) one with noisetorch.

Don't know if you are looking for the same - NoiseTorch - Works like a charm.