crouton VS wireguard-docs

It's a little more than that, they then added subpixel and momentum scrolling support to Chrome that bypasses X11 and does something custom [1]. Integration problems like this one that require a bunch of coordination are harder to do in open source land.

1. https://github.com/dnschneid/crouton/issues/244

I'm guessing GP means natively, not in a VM. I've been super grateful for the VM-based method, but I still prefer the native experience like that provided by Crouton[1]. With Crouton being "maintenance-only" now I share GP's hope that a similar thing will be possible and easy.

[1]: https://github.com/dnschneid/crouton

One way to install Crouton

Go to the github of crouton they have instructions there https://github.com/dnschneid/crouton

At any rate, you can try Breath, Crouton, Manjaro... those are three of the distros people have found success with. It all boils down to the specific hardware involved... which we know nothing about since you kept that to yourself.

Post in r/crouton and refer to https://github.com/dnschneid/crouton if you haven't already. However, I think it's fair to say that Crouton is now broken to the point of being effectively dead.

I can’t find info about this in the quickstart guide. Are these the docs you’re talking about?

I think the official documentation is clear enough on the settings, and I don’t think the project can necessarily be blamed for others misinterpreting it. True, the AllowedIPs label can lead to some confusion for those who don’t read the docs. I think of it as those destination IPs that can be reached through the peer, and those source IPs that are accepted from the peer. See also this site: https://docs.sweeting.me/s/wireguard

You prolly should give a /32 on your interface ips. Here is this as well https://github.com/pirate/wireguard-docs. I don't understand exactly what you are trying to do, but if you are trying to pass traffic anywhere you need to enable packet forwarding at the Kernal level.

By the way, look at https://github.com/pirate/wireguard-docs

Thanks for the reply. I'm not sure which missing lines you're referring to though? According to this documentation, PostUp is used to run a command after the interface is initialised (same for PostDown, which apparently runs a command after the interface is deleted), but I'm not sure what commands exactly I'd need to run PostUp or PostDown for?

Find more example commands for inspecting the interface at https://github.com/pirate/wireguard-docs#inspect.