Print-Tuning VS klippain

;PRINT_START ;; If you are passing variables to PRINT_START, comment out above line and uncomment the last 3 lines instead. ;; Guide: https://github.com/AndrewEllis93/Print-Tuning Guide/blob/main/articles/passing_slicer_variables.md ;; Make sure the variable names match (for example if you use "EXTRUDER" instead of "HOTEND") M104 S0 ; Stops PS/SS from sending temp waits separately M140 S0 PRINT_START BED[first_layer_bed_temperature] HOTEND{first_layer_temperature[initial_extruder]+extruder_temperature_offset[initial_extruder]}

Regarding the MCU, it's actually 2 layers of boards_pins that are used in Klippain and I think you only looked at the second layer. You can get more info on this here: https://github.com/Frix-x/klippain/blob/main/docs/pinout.md

Most slicers allow passing the material type as a variable to your print start macro, you can then do logic based on that to determine if you want to soak, etc. Check out this repo for some ideas https://github.com/Frix-x/klippain

If you want to try it out or have a look, it's available here: https://github.com/Frix-x/klippain