firmware VS pwnagotchi

Contains closed source binary blobs. It’s commercial with open source components.

https://github.com/OpenIPC/firmware/issues/230#issuecomment-...

https://github.com/OpenIPC/firmware

You can get onvif-compliant firmware for some of those, but battery-powered operation cannot be expected to remain practical, given what onvif focuses on.

> Majestic code while is not open, provides unprecedented performance and capabilities for a wide range of hardware. The author of Majestic streamer is looking into possibilities to open-source the codebase after he secures enough funds to support further open development. You can help to make it happen sooner.

Source: https://openipc.org/

Crazy wide amount of chips supported. My main barrier would be that my current camera has nice hardware h.265 encoding. I haven't dug deep but whether I can keep that or not would be a potential deal breaker.

Github: https://github.com/OpenIPC/firmware

The OpenIPC project has more recent code for these chips (though even that seems to be 4.9) https://openipc.org/

Check out OpenIPC for custom opensource firmware on a variety of devices

At least in terms of software/firmware there is some. https://openipc.org

Merged and corrcted in jan could try that or as mentioned in another comment w solved this a while back in the forums remember to run the demo on your unit to verify what drivers it needs etc but it's been solved long ago https://github.com/evilsocket/pwnagotchi/issues/1134

yeah cause when you enable pwnagotchi to use pwngrid all you actually did was tell pwnagotchi to use api/pwnagotchi.ai which is down so your pwnagotchi will now try to connect to the internet, then it will try to send data to the API at pwnagotchi.ai and that API has been removed from the site. this is like telling the babysitter to call grandma but grandmas phone got cut off after a bad storm you can dial the number all day the wire to the house got cut there's no way for you to connect that way right now...

ok so all the Drivers for all the supported boards are added to the lib folder during build so if you add that stuff to the repo you download before you build it into an image. then adjust the display.py file to have a call back for your new drivers then you can set config to call up your screens drivers. After that you may need to adjust voice.py in order for screen element to display correctly based on your eink resolution.

Use the same config from pwnagotchi.ai but use this Image

1st Image used: https://github.com/evilsocket/pwnagotchi/releases/tag/v1.5.5

fatal: unable to access 'https://github.com/evilsocket/pwnagotchi.git/': Could not resolve host: github.com