OctoPrint-TPLinkSmartplug VS OctoPrint-BedLevelVisualizer

I have a tplink socket on my printer so im using the TP-Link Smartplug plugin and iv got it configured with as:

My TP Link HS103 stopped working with Octoprint likely as a result of the recent firmware update. And what's weird is that there is a workaround to get the HS103 working again with the TPLinkSmartPlug plugin, which I followed. Octoprint started controlling the smart plug again - yay! But it stopped working again after a while. Boo. :(

2022-01-07 17:16:28,821 /home/pi/oprint/bin/python3 -m pip --disable-pip-version-check install file:///tmp/tmpy9sw1vew/Octoprint-Smart-Filament-Sensor-master.zip --no-cache-dir pip install "https://github.com/jneilliii/OctoPrint-TPLinkSmartplug/archive/master.zip

The P100 seems to be known to not be able to function at all: https://github.com/jneilliii/OctoPrint-TPLinkSmartplug/issues/131

I want to use this plugging for octoprint: https://github.com/jneilliii/OctoPrint-TPLinkSmartplug But i have fluid, is it possible ? I installed fluid after Nero's 3D video : https://youtu.be/gfZ9Lbyh8qU

I use this one: https://github.com/jneilliii/OctoPrint-TPLinkSmartplug It should be available from your octorpint dashboard, that's how I downloaded it a year ago. Best upgrade ever, I can leave prints overnight and when they're done the printer and a light connected to it turn off automatically after cooldown.

Follow the setup instructions on the main plugin page for inputting your plug's IP address. Make sure "Enable GCode Trigger", "Auto Connect", and "Auto Disconnect" are checked on.

The first included marlin example worked for me:

I'm using a CR-10v3 with a BL-Touch v3.1 for 4.2.7 mainboard addon. Printer is using the Klipper firmware and as such, doesn't recognize commands like M420. Based on the example GCODE on the BedLevelVisualizer page, I'm using:

Install the Bed Visualizer plugin in Settings add the gcode from https://github.com/jneilliii/OctoPrint-BedLevelVisualizer/blob/master/wiki/gcode-examples.md for the Sidewinder X2 (you might want to modify the temperatures).

Depending on firmware, I just used what they suggested here: https://github.com/jneilliii/OctoPrint-BedLevelVisualizer/blob/master/wiki/gcode-examples.md

One final note for those looking around, Bed Visualizer has different examples of some G code found here: https://github.com/jneilliii/OctoPrint-BedLevelVisualizer/blob/master/wiki/gcode-examples.md which I'm looking at as well, but didn't want to add more complexity until I figure out what's going on.

I agree with the other commenter that the middle is too low. If you're using Octoprint at all, you can install the Bed Level Visualizer plugin to get a good visual.