Nevermore_Micro VS Klicky-Probe

I just built a Nevermore into my Voron 2.4. They have other models that you can check as well that fits other printers.

Nevermore Micro v6

Mind telling a bit more about nylon toxicity during printing? According to this: https://github.com/nevermore3d/Nevermore_Micro nylon emits caprolactam, which hasn't been found to be either toxic or not according to wikipedia.

Check out the shop links here https://github.com/nevermore3d/Nevermore_Micro

Trying to print the Nevermore filter. Doing the v5 duo XL.. this one

If you have a well sealed enclosure make or buy already printed from etsy NEVERMORE Filter then fill it with ONLY carbon that has NOT been acid washed.

I used this github as a guide to get my servo to work on my BTT SKR Mini E3 V3 https://github.com/jlas1/Klicky-Probe/tree/main/Printers/Voron/Switchwire then you have to mess with the pulse width value until it works right, lots of trial and error

So you want to use this one? https://github.com/jlas1/Klicky-Probe/tree/main/Printers/Voron/Switchwire

GitHub, there's the install for all the different variants (klicky, unklicky and the ng variants), with macros, boms and instructions https://github.com/jlas1/Klicky-Probe

I just went through the same build and I just included the klicky files as specified here, edited the variables file and that was it

The official Klicky setup for the Switchwire uses one as well