Klipper-Adaptive-Meshing-Purging VS print_area_bed_mesh

Try KAMP: https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging/tree/main

2) I am trying to install KAMP which I have working, but again this does not surive a reboot because the Klipper-Adaptive-Meshing-Purging folder (in the root directory) is deleted each time.

As far as I know, the KAMP is configured correctly. The installation was successful, I've followed the steps from the Github page, but I'm fairly certain that I'm missing something from my START_PRINT macro that's keeping it from working.

gcode: # KAMP https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging EXCLUDE_OBJECT_DEFINE SETUP_KAMP_MESHING DISPLAY_PARAMETERS=1 BED_MESH_CALIBRATE

I combined KAMP (https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging) with the MAX_DEVIATION option to SCREWS_TILT_CALCULATE and now before every print my printer checks the bed screws, and if they are off by more than 0.05mm it aborts the print. It then does an adaptive bed mesh and then purge. All together it doesn’t usually add much time, and I’ve been getting consistently good first layers.

This is what I use for my adaptive purge (and mesh) - https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging

But then again, just TAP with KAMP is already fine enough for pretty much everyone.

That is the one I used to use for a long time until KAMP came around.

taken from here: Klipper-Adaptive-Meshing-Purging/Adaptive_Mesh.cfg at main · kyleisah/Klipper-Adaptive-Meshing-Purging · GitHub and bed mesh config is the standard config found here Secondary Printer Tuning | Voron Documentation (vorondesign.com) with the uncomments made for the 350 build

A macro that only probes the bed area that you are printing in aka dynamic bed mesh probing! https://github.com/Turge08/print_area_bed_mesh

Well i just wanted to use this bed mesh plugin https://github.com/Turge08/print_area_bed_mesh

print_area_bed_mesh GitHUB

Unparsed config option 'origin: https://github.com/Turge08/print_area_bed_mesh.git' detected in section [update_manager print_area_bed_mesh]. This may be an option no longer available or could be the result of a module that failed to load. In the future this will result in a startup error.

Gives this a try, it wont fix your problem but auto adjust your probed area to your print area. https://github.com/Turge08/print_area_bed_mesh

If you want to get fancy with it, check out this little gem: print_area_bed_mesh

By print_size_mesh, do you mean this macro? https://github.com/Turge08/print_area_bed_mesh

My main reason to start using it was because of a macro (not this one, but it's a better one) that only generates a mesh for the area you will be printing in. It can also reuse meshes if the new mesh is the same size or smaller than the last. Of course you can just generate one mesh and run with it for awhile, but I like having as fresh a mesh as I can and this saves time.