Firebase-ESP8266 VS Adalight-FastLED

Instead, using this one: https://github.com/mobizt/Firebase-ESP8266 it stop working after uploading the code on the WiFi module (Arduino UNO bridged by RST > GND) as you can see from the screenshot attached:

There may be dependency libraries that haven’t been installed. Try following this guide in the readme section

Searching online there's also https://github.com/mobizt/Firebase-ESP8266 might be worth trying

Then you might want to look into firebase. The free plan will probably be sufficient for your private use and there's even Arduino library for it https://github.com/mobizt/Firebase-ESP8266

Software and Hardware used: I am using Adalight Fastled (https://github.com/dmadison/Adalight-FastLED) with a WS2812B strip.

Run Adalight with Prismatik.

The sketch I used for the DIY Ambilight can be found here: https://github.com/dmadison/Adalight-FastLED/blob/master/Arduino/LEDstream_FastLED/LEDstream_FastLED.ino

Use this code instead. Define the LED type, data, and clock pins at the top.

Of course, here it is: https://github.com/dmadison/Adalight-FastLED

I have uploaded a sketch Adalight-FastLED to an Arduino Mega. The following description is the requirement for my c# app that is using a slightly modified Ardity to send byte[] instead of strings to the Arduino.

another warning: the off the shelf kits come with a relatively low baked-in baudrate (115200, but confirm with your seller), this might limit your LED framerate, read this, so don't set your software to 360-noscope-fps capture right away... so either you are fine with what you'll get and you leave it at that or you want a higher rate, in which case you'll need to flash it with any other arduino ambilight sketch (such as this) with values that work for your board (any arduino ambilight tutorial on the subject will do)

I used this: https://github.com/dmadison/Adalight-FastLED If you need any further help, dm me. I'm electrician, so I didn't need to learn how the electronics work.