Arduino_Core_STM32 VS picodvi

There's nothing stopping Arduino releasing an STM32-based dev board - but they simply haven't yet, and there's stacks of stm32 boards around that you can add an Arduino support core for if you like.

https://github.com/stm32duino/Arduino_Core_STM32 look this

It shows this https://github.com/stm32duino/Arduino_Core_STM32/archive/main.zip getting to 97% then skipping to the next unpacking, then it seems to fail thereafter.

You can program an STM32 MCU with Arduino, just add the community developed board definitions and HAL to the Arduino IDE.

If the mcu disables itself after it's one use you could program it via arduino to reset it or give it a new purpose. Reprogramming the chip will likely be the best use, those components are only a few cents it's more effort than it's worth to save them. Repurposing the board is what I'd try to do, weather that's via replacing the stm32 or reprogramming it is up to you.

I am using the stm32duino core for the Arduino Ide (https://github.com/stm32duino/Arduino_Core_STM32). My settings are the following:

(official Arduino HAL) STM32

The RP2040 is a great MCU for playing with graphics as it can bit bang VGA and DVI/HDMI. There's some info on the DVI here: https://github.com/Wren6991/PicoDVI

I wrote a couple of articles on how to do bit banged VGA on the RP2040 from scratch: https://gregchadwick.co.uk/blog/playing-with-the-pico-pt5/ and https://gregchadwick.co.uk/blog/playing-with-the-pico-pt6/ plus an intro to PIO https://gregchadwick.co.uk/blog/playing-with-the-pico-pt4/

A few years back someone was bit banging DVI and 720p 30fps video straight off the RP2040 GPIO pins with just inline resistors between not and the HDMI cable.

https://github.com/Wren6991/PicoDVI

I have the Adafruit DVI board and have been hacking on it some. It's more fun than should be allowed.

There's a project to get this running using Rust[1]. Currently it outputs the blue channel with sync, but has trouble with the other two channels. I don't have a hardware lab with scope, logic analyzer, etc., so it's not easy for me to debug.

In the meantime, I've been doing some experiments in the C codebase as well[2], mostly in the direction of proportionally spaced bitmap text, using the fonts in the X11 distribution.

[1]: https://github.com/DusterTheFirst/pico-dvi-rs

[2]: https://github.com/Wren6991/PicoDVI/pull/48

There is even bit-banged DVI library for pico.

Apparently, there is a digital video output project for the RP2040 already out there [0]! As for why digital video is more rare, it is because the common digital video formats are higher bandwidth and require higher signal integrity.

[0] https://github.com/Wren6991/PicoDVI

I've seen people implement DVI with PIO, and I'm sure basic missile commands wouldn't be as bandwidth-intensive as that.

For example this guy (https://github.com/Wren6991/PicoDVI) essentially 'bit bangs' CML. Sure its not a completely compliant implementation, but it's pretty close... In his case using a push pull with 3.3V/0V. I don't know how he's getting a 0.8V swing.