Our great sponsors
-
grbl-Mega
An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on an Arduino Mega2560
-
WorkOS
The modern identity platform for B2B SaaS. The APIs are flexible and easy-to-use, supporting authentication, user identity, and complex enterprise features like SSO and SCIM provisioning.
I've flashed my Arduino Mega 2560 with grbl-mega, which is supposed to allow grbl to be used with the arduino mega2560. It looks like it flashes OK - I can talk to it with the serial monitor. But, I'm trying to install it to UGS using the Setup Wizard. No luck! I get the error message every time that it doesn't know how to configure this controller - and that it must be configured manually. I tried to go into 'firmware settings' to configure it manually, but the option is greyed out under the 'machine' menu. I think it cannot connect to my board at all. I'm a little bit lost about what to do next. Has anyone been through this, using UGS + Arduino Mega2560?
grblHAL has no Arduino Mega version. supported grblHAL controllers
UGS platform 2.0.11
Related posts
- UGS opening file issue
- Problems with UGS and grbl 1.1. It is constantly spamming this, I can't do anything without it starting again. Have restarted and reset everything, I'm at a loss. Appreciate any help
- What software are you using with your Inventables Carvey?
- UGS Follow G-Code Progress Throughout Job
- No serial port found - CNC machine - Universal G Code Sender