jorne VS Lily58

jorne an extended Corne keyboard with extra keys for brackets and international layouts. Available in cherry, chocolate, classic and light variants (same as original)

Jian and Jorne – extra pinky key instead of extra thumb key

Jorne – extra keys

https://github.com/joric/jorne/wiki/Trackpoint is helping answer many questions

Cheapest way would be ordering all electronics from aliexpress, and PCBs from jlcpcb. It's definitely not the easiest nor fastest way though. If you'd go with ordering yourself then I highly recommend this wiki https://github.com/joric/jorne/wiki

This is the closest I could find https://github.com/joric/jorne

Just follow the excellent guide here. It has BOM with aliexpress links, pcb gerbers that you can simply upload to PCB making website, files for top/bottom case plates

The hardware is one half of the DIY split ergo-mech Lily58: <https://github.com/kata0510/Lily58>

The FrogPad-inspired part is the firmware/layout for only one hand.

You will need to do further testing with a multimeter to determine what is connected that shouldn't be. This may be easier if you look at the pcb design schematics.https://github.com/kata0510/Lily58/tree/master

You can find it here on the official github repo https://github.com/kata0510/Lily58/tree/master/Pro/PCB

Hello everyone, I've wanted to get into ergo keyboards for a while now and this holiday season I've decided to give the gift of less wrist problems to family and friends, but I can't be sure that all the parts I'm looking for are exactly what I need, I've been looking at AliExpress and trying to buy the stuff to make a couple of lily58-pros as detailed in: https://github.com/kata0510/Lily58/blob/master/Pro/Doc/buildguide_en.md also will probably print the PCBs on jlcpcb

After the release of Corne GLP, there has been significant interest among community members in trying out Gateron Low Profile switches. That's why I created Allium58 based on the Lily58 Pro created by kata0510.

The Lily58 github page doesn't have a gerber.zip. I downloaded Kicad (first time using it) and was able to produce a gerber for the right PCB, but I don't know how to mirror the design to create the left PCB. Any idea how to do this? I tried the mirror button in the toolbar but some parts came out not aligned properly.

I went for a lily58 as my split keyboard and they have a pretty good build guide https://github.com/kata0510/Lily58/blob/master/Pro/Doc/buildguide_en.md

After some initial research, I've found a couple of models that seem to meet my requirements: the Lily58 and Redox-w v2.

Only found adobe illustrator files. https://github.com/kata0510/Lily58/blob/master/case/Lily58_case.ai