My_Mars2Pro_Accessories VS mariner

I highly recommend you check out the faq section of this sub as well as this general information longpost for some basic information on how the printer and printing works. Be advised though, i think the latter is from before mono printers came out so I'd recommend looking up more detailed information on those seperately as well.

Yup, those are handles.

I wrote the process I use here: https://github.com/rkolbi/My_Mars2Pro_Accessories/blob/main/MARS-r2.md

If you're printing it with FDM, the split file should print fine - just pull it apart when done, but resin is a different story - I just didn't think about it as I was using a FDM for it. So, since you asked for it, I split the two halves into separate files. They can be found here and here.

I while ago I made a getting started guide that me prove helpful, you can find it here.

To actually do a resin calibration, you can look at the videos here or here. I've also made a quick FAQ guide they may be of additional help here.

I made this drip adapter a while ago, works well. The design is FDM friendly.

-The last step, write the correction factor on the bottle. I made/use these labels on my resin bottles with an aquarium stick-on thermometer alongside them.

You can try mariner https://github.com/luizribeiro/mariner

I use mariner 3D (https://github.com/luizribeiro/mariner). it provides a web interface that allows you to upload files and start prints. you can also use sshfs, smb, or nfs to mount it as a remote filesystem. all you need is a pi zero, some usb cables, and jumper cables to hook up the printer's control board. i printed a pi case the mounts to the printer using the side panel.

Mariner is what you want. You use a Raspberry Pi Zero W as a wireless thumb drive, and it runs Mariner software to monitor and control your printer via gpio pins. https://github.com/luizribeiro/mariner

Looks like it’s an issue with Chitubox. Use a different slicer and see if you can get a gcode file Chitubox and CTB