MKS-H43 VS Neptune-Elegoo3-Klipper

https://github.com/makerbase-mks/MKS-H43 this one seems to be the screen used by the way

Good find. I’ll give it a go. I think this screen is based on Makerbase H43, not sure if we can customise its interface https://github.com/makerbase-mks/MKS-H43

Yeah I think that's what it defaulted to in the marlin configs, we can possibly do custom themes also, https://github.com/makerbase-mks/MKS-H43/blob/main/Images/H43.png

You can compile the printer firmware yourself following the guide but there are precompiled versions for the N3 floating around, see below. You can flash the firmware in this repository which is precompiled. This repository has a config which is a bit more current so I would use that but you can modify the config in klipper on the fly so you don't need to worry about that you get klipper running.

I am using Putty and I have configured the printer with the instructions on [this github page](https://github.com/jerryngm/Neptune-Elegoo3-Klipper)

You don’t need to do Probe_calibrate as the nozzle is essentially the probe so offset is 0. You can use the config here https://github.com/jerryngm/Neptune-Elegoo3-Klipper/blob/main/printer.cfg

Since I can't bed level (this printer is only automatic leveling, not manual), I can't print. Any idea what I'm doing wrong here? I just want to get it to let me set z-height and develop the mesh. I used the firmware from here: https://github.com/jerryngm/Neptune-Elegoo3-Klipper

You can use value from the Marlin to calculate it, or try out the config here https://github.com/jerryngm/Neptune-Elegoo3-Klipper