Ender-S1-Klipper-Config VS Klipper-Adaptive-Meshing-Purging

Try KAMP: https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging/tree/main

2) I am trying to install KAMP which I have working, but again this does not surive a reboot because the Klipper-Adaptive-Meshing-Purging folder (in the root directory) is deleted each time.

As far as I know, the KAMP is configured correctly. The installation was successful, I've followed the steps from the Github page, but I'm fairly certain that I'm missing something from my START_PRINT macro that's keeping it from working.

gcode: # KAMP https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging EXCLUDE_OBJECT_DEFINE SETUP_KAMP_MESHING DISPLAY_PARAMETERS=1 BED_MESH_CALIBRATE

I combined KAMP (https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging) with the MAX_DEVIATION option to SCREWS_TILT_CALCULATE and now before every print my printer checks the bed screws, and if they are off by more than 0.05mm it aborts the print. It then does an adaptive bed mesh and then purge. All together it doesn’t usually add much time, and I’ve been getting consistently good first layers.

This is what I use for my adaptive purge (and mesh) - https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging

But then again, just TAP with KAMP is already fine enough for pretty much everyone.

That is the one I used to use for a long time until KAMP came around.

taken from here: Klipper-Adaptive-Meshing-Purging/Adaptive_Mesh.cfg at main · kyleisah/Klipper-Adaptive-Meshing-Purging · GitHub and bed mesh config is the standard config found here Secondary Printer Tuning | Voron Documentation (vorondesign.com) with the uncomments made for the 350 build