Pleae help with my Bltouch set up. Professional firmware. Bed has been scrapped bad during homing.

This page summarizes the projects mentioned and recommended in the original post on reddit.com/r/ender3v2

Our great sponsors
  • SonarLint - Deliver Cleaner and Safer Code - Right in Your IDE of Choice!
  • OPS - Build and Run Open Source Unikernels
  • Scout APM - Less time debugging, more time building
  • GitHub repo Marlin_Ender3v2

    This Marlin is an optimized firmware for Ender 3v2 3D printers. | It is based upon original Marlin repository and has many improvements from the bugfix branch.

    Check your BLtouch connections, this firmware uses the five pin bltouch connector as can be found in this guide https://github.com/mriscoc/Marlin_Ender3v2/wiki/3D-BLTouch also check if you install the correct bltouch firmware version.

NOTE: The number of mentions on this list indicates mentions on common posts plus user suggested alternatives. Hence, a higher number means a more popular project.

Suggest a related project

Related posts