wireguard-install VS wg-easy

Пользуйся наздоровье: https://github.com/angristan/wireguard-install

If you want an easy setup I suggest using a script like this. Even a novice should be able to set up Wireguard in about half an hour - assuming they already have a DynDNS service set up.

I personally use this script to setup a wireguard server. Doing it by hand is totally possible but this makes things a bit easier.

"Free" OpenVPN is nothing special, you can just run the PiVPN or Angristan's OpenVPN script on any of those VPSes. Ultra.cc's built-in VPN only support up to 3 simultaneous session, while those scripts allow unlimited sessions (at least until you maxed the CPU with hundreds of MBps transfer), you can get faster speed & lower latency with WireGuard on PiVPN, or using Angristan's WireGuard script, if your ISP tries to block OpenVPN & WireGuard, you can use Outline etc.

You can use something like this if you are familiar with the command line and have something like a Raspberry Pi: https://github.com/angristan/wireguard-install

I know that tailscale uses wireguard. I set up my wireguard server using a script Perhaps this speed is due to the fact that I live in Russia, and my wireguard server is located in the Netherlands. I also heard that tailscale connects clients directly to each other (as I understand it)

I recommend this script: https://github.com/angristan/wireguard-install

This wg-easy?

Definitely not an OSI approved license, but does look like they made an attempt in the spirit of GPL, no?

https://github.com/wg-easy/wg-easy/blob/master/LICENSE.md

> You may:

Use this software for yourself;

Use this software for a company;

Modify this software, as long as you:

Publish the changes on GitHub as an open-source & linked fork;

Don't remove any links to the original project or donation pages;

You may not:

Use this software in a commercial product without a license from the original author;

Just plain wg-easy (wireguard with frontend). No 3rd parties involved, just me & my endpoint

https://github.com/wg-easy/wg-easy (7.6k stars)

You can however skip the VPS part if you run your own wireguard or OpenVPN server at home and route your traffic from work through your home. See this for a dead simple wireguard setup https://github.com/wg-easy/wg-easy. Your home takes the VPS place in that example. There are some limitations though that might depend on your ISP. If you are able to selfhost things in general and make them accessible from outside your home with your ISP setup, then you should be able to use wg-easy and not need to buy a VPN or a VPS.

Check out wg-easy. I've found it relatively painless to configure and get clients connected via wireguard.