unpackerr VS rtl_433

I just found a project called Unpackerr which sounds like an absolute dream for me, it would fix my unpacking issue. I have Truenas Core installed, and found a guide for installing on Truenas scale here. During the container configuration, you need to set up some environmental variables.. is this possible to do on Truenas Core?

nope, unpackerr works across multiple systems: https://github.com/Unpackerr/unpackerr

Unpackerr

For anyone reading this, Unpackerr is by far the better solution to packed torrents.

I don't, that's what unpackerr's for.

You can run Sonarr, Radarr, Flaresolverr(if your tracker is behind Cloudflare protection), Deluge, Unpackerr, and Overseerr on Windows.

Also, you can use unpackerr

Check out Unpackerr. I haven't had any issues with extraction since using it

And there's a multiformat receiver block too: https://github.com/merbanan/rtl_433

pi@pi4b8:/etc/systemd/system $ cat rtl_433.service # based on https://github.com/merbanan/rtl_433/issues/1651 [Unit] Description=RTL_433 service script StartLimitIntervalSec=5 Documentation=https://github.com/merbanan/rtl_433/README.md After=syslog.target network.target [Service] Type=exec ExecStart=/usr/bin/rtl_433 -C si -F mqtt # Restart script if stopped Restart=always # Wait 30s before restart RestartSec=30s # Tag things in the log # View with: sudo journalctl -f -u rtl_433 -o cat SyslogIdentifier=rtl_433 StandardOutput=syslog StandardError=syslog [Install] WantedBy=multi-user.target

For example, rtl_433 has the spec for an X10 sensor say I know what data I want to put where, is there some tool/site I could enter in what the "specifications" of the signal waveform are and the data I want to send as a byte-string or binary-string and it would create a playable .sub file for me?

For "outdoor distances" I'd probably stick to something LoRa or 433MHz based. YoLink has quite a few options using the LoRa protocol. I use basic 433Mhz based AcuRite sensors paired with an RTL-SDR dongle connected to a machine running RTL_433, and use Home Assistant to trigger automations and alerts.

866-868MHz is SRD/ISM band (in UK/EU). Can be things like energy meters, TPMS, medical devices etc. Try rtl_433 on it.

I'm trying to add a Honeywell doorbell to Home Assistant by using the RTL-433 GitHub project/program. When I run the program the SDR dongle is detected but it doesn't display anything when I press the doorbell (the image shows what I see after running the program and pressing the doorbell). I have also tried Honeywell Activelink (FSK) aka [116], so I have tried both 115 and 116 decode protocols.

rtf_433 IoT & embedded device signal receiving https://github.com/merbanan/rtl_433